Advertisement
Getting Started: Installation and Adjustment Procedure (continued)
ADJUSTING FT-01B continued:
Turn knob (2) clockwise:
Turn the knob (2) clockwise until the reflection
line appears in the screen.
* Reflection line
Reflection of the laser curtain from the FT-01B
to the surface of the whiteboard
Turn knob (3) clockwise:
Turn the knob (3) clockwise so that the reflection
line is horizontal.
Turn knob (1) clockwise:
Turn the knob (1) clockwise so that the reflection
line moves near the vertical center.
Turn knob (2)/(3):
If the reflection line is not horizontal, use knob (2)
or (3) to make the reflection line horizontal.
Turn knob (1) clockwise:
Turn the adjustment knob (1) clockwise again and
move the reflection line upward.
If the reflection line tilted, use knob (2),(3) and make
it horizontal.
Turn the knob (1) clockwise again until one dot, not
two, appears at the both left and right of the screen.
These dots are the reflection from the dot on the
Adjusting-bars which attached at the bottom of the
image.
urn knob (1), slowly, counter-clockwise:
T
Turn the knob (1), slowly, counter-clockwise until the
two dots appears at the right and left of the image.
* This means that the Laser-curtain from the
FT-01B, is hitting on the two side-dots, close to
the boundary-line of one center-dot and two side-
dots, of the each Adjustment-bars and the laser-
curtain is covering the whole image surface with
decent distance.
EXIT the CAMERA VIEW:
Push right-button of remote and Exit from
CAMERA VIEW.
Side
Side
dot
dot
Center dot
Adjustment bar
White board
Advertisement
