Leveling Your Washer - Samsung WA40J3000AW User Manual

Connecting the drain hose
The end of the drain hose can be positioned in
three ways:
Over the edge of a wash basin
Secure the guide to the side of the basin wall
with a hook or to the tap with a piece of string to
prevent the drain hose from moving.
In a standpipe or laundry tub
The standpipe must be no shorter than 39 in (99
cm) and no longer than 96 in (245 cm).
Make sure that the connection between the
drain hose and the standpipe is not airtight.
The Drain Hose can be installed up to 96 in (245cm)
above the floor, but the draining capability can be
reduced at this height. This can cause the washer to
have an odor because of water remaining in the drain
system.
Laundry tub
Hose
retaine
96
39
Tie
strap
_ Connect the hose guide no more than 4 in
(10cm) from the end of the drain hose. If the drain hose
extends more than 4 in (10cm) beyond the end of the _ __
hose guide, mold or microorganisms could spread to the
inside of the washer.
No more than
4 in (10em) _.......
Hose Guide
lf the drain hose is installed below 39 in (99cm), water
can drain during wash cycles due to a siphon effect.
If this occurs, it causes the Tap cold LED on the washer to flash.
Standpipe
STEP 3
Leveling your washer
See if the washer is level by checking the position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour the water into the tub to
just below the pulsator level.
Adjustable legs
3,
If the washer is level, the pulsator will be centered in the washer as
shown in the figure. If the pulsator is not centered, level your washer
by turning the front leveling feet clockwise or counterclockwise as
necessary.
[_ urn the front levelinq feet clockwise to raise the washer, and
counterclockwise to'lower the washer.
Engl sh- 15
\\TA3000]\\TA40_3000A_%'USEI_.\IANUALDC6803520AJndd 15 2015/4/10 14:53:23