Page 1
INSTRUCTION MANUAL Angle Grinder 9067/9067S/9067L 9069/9069S 001011 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ENGLISH SPECIFICATIONS Model 9067/9067S 9067L 9069/9069S Depressed center wheel diameter 180 mm 180 mm 230 mm Spindle thread No load speed (n ) / Rated speed (n) 8500 min 6600 min 6600 min Overall length 458 mm 458 mm 458 mm Net weight 4.2 kg...
increase the risk of electric shock. Power tool use and care Do not abuse the cord. Never use the cord for 18. Do not force the power tool. Use the correct carrying, pulling or unplugging the power tool. power tool for your application. The correct Keep cord away from heat, oil, sharp edges or power tool will do the job better and safer at the rate for which it was designed.
Page 4
and/or serious injury. may fly away and cause injury beyond immediate Operations such polishing area of operation. recommended to be performed with this power 10. Hold power tool insulated gripping tool. Operations for which the power tool was not surfaces only, when performing an operation where the cutting accessory may contact designed may create a hazard and cause personal injury.
Page 5
forces, if proper precautions are taken. the point of operation, is moving away from your b) Never place your hand near the rotating body, the possible kickback may propel the accessory. Accessory may kickback over your spinning wheel and the power tool directly at you. hand.
20. Before using the tool on an actual workpiece, WARNING: let it run for a while. Watch for vibration or DO NOT let comfort or familiarity with product wobbling that could indicate poor installation (gained from repeated use) replace strict adherence or a poorly balanced wheel.
Page 7
For tool with the lock-off switch To prevent the switch trigger from accidentally pulled, a CAUTION: lock lever is provided. The wheel guard must be fitted on the tool so that • To start the tool, push in the lock lever and then pull the the closed side of the guard always points toward switch trigger.
NEVER bang or hit grinding disc or wheel onto • 1. Lock nut wrench work. 2. Shaft lock Avoid bouncing and snagging the wheel, especially • when working corners, sharp edges etc. This can cause loss of control and kickback. NEVER use tool with wood cutting blades and •...
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Wheel guard (Wheel cover) •...
Page 12
Makita Corporation Anjo, Aichi, Japan 884183-773...