Displaying The Area Marker Or Aspect Marker - Sony BVM-F170 Operation Manual

Displaying the Area
Marker or Aspect Marker
The monitor is equipped with two area markers and center
marker as the safe area marker and aspect marker for
confirming the picture angle.
1
Input the signal.
2
Select the channel.
3
Set the marker preset data (Marker1 to Marker5) to
display in the Marker Preset menu (page 49) of the
Channel Configuration menu.
4
Set the marker to display in the Marker Setting menu
(page 52) of the Function Setting menu for the preset
data set in step 3.
5
Select the marker mode (Marker, Aspect Marker, Area
Marker 1, Area Marker 2, Center Marker, Aspect
Marker-Line, Aspect Blanking-Half or Aspect
Blanking-Black) with the function button
controller or in the Function Switch menu (page 56) of
the Function Setting menu and set it to On.
1) Each function of the marker is assigned to the function button of the
controller in the Function Key menu (page 72) of the Controller
menu.
When the MARKER button is set to on
All the markers that are set to On in the Marker Setting
menu of the Function Setting menu are displayed.
The MARKER button lights.
To display the aspect marker
Set the button of the marker mode that you wish to
display (Aspect Marker, Aspect Marker-Line, Aspect
Blanking-Half or Aspect Blanking-Black) to on.
The MARKER, Aspect Marker and the pressed button
light.
To display the area marker 1, area maker 2 or
center marker
Set the button of the maker that you wish to display
(Area Marker 1, Area Marker 2 or Center Marker) to
on.
The MARKER and the pressed button light.
To cancel the marker display
Set the MARKER button to off.
Note
Use the controller with software version 1.6 or higher
to assign Center Marker, Aspect Marker-Line, Aspect
Blanking-Half or Aspect Blanking-Black to a function
button of the controller.
1)
of the

Displaying the Area Marker or Aspect Marker

83