Turn Signal Switch (Int'l); Hazard Switch (Int'l); Transmission (Gear Position) Switch - Polaris 2014 RZR XP 1000 Service Manual

ELECTRICAL

Turn Signal Switch (INT'L)

1. Disconnect the Turn Signal switch harness by
depressing the connector locks and pulling on the
connector. Do not pull on the wiring.
2. Test between the 5 sets of outputs (HI BEAM / LO
BEAM / L-TURN / R-TURN / HORN). If any of the
tests fail, replace the switch assembly.
10.16

Hazard Switch (INT'L)

1. Disconnect wires or harness from the Hazard switch.
2. Test between the outputs (ON / NONE / OFF). If any
of the tests fail, replace the switch assembly.
• Move switch to ON. There should be continuity
• Move switch to NONE / OFF. There should be no

Transmission (Gear Position) Switch

1. The transmission (gear position) switch is located on
the RH side of the transmission and can be
accessed through the RH wheel well area.
2. Disconnect the transmission switch harness by lifting
the connector lock and pulling on the connector. Do
not pull on the wiring.
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
between switch pins 2 and 3.
continuity between switch pins.