Table of Contents
Advertisement
Adapt-a-Valve Installation
Caution: Water supply line to the system must be from the cold water supply line only.
Hot water will severely damage your system.
Verify contents prior to installation:
( 1 ) - Plastic Adapt-a-Valve with black collet
( 1 ) - Brass Adapter no washer
( 1 ) - Brass Adapter with black washer
( 1 ) - White rubber washer
*
White
Washer
A
3/8" Confi guration
(With Brass Fittings)
* Insert White Washer
WARNING:
Do not use Tefl on tape with the Adapt-a-Valve.
Step 7
Turn off the cold water supply to the faucet by turning the angle stop valve completely off.
Open cold water sink faucet to relieve pressure.
Choosing the confi guration that fi ts your plumbing, attach the adapt-a-valve as illustrated in
Step 8
the four photos above.
TIPS:
Make sure that the black collet is installed in to the 1/4" opening on the Adapt-a-valve.
Don't forget to install the white compression washer with the 3/8" confi guration.
Brass adapter (A) does not need to be tightened with a wrench, only fi nger tight.
Reverse Osmosis Module Mounting
Determine best location for the RO module to be mounted to allow
Step 9
for future system maintenance. Using the mounting holes on the
bracket, mark the location for the mounting screws on the cabinet
wall under the sink. In the parts bag, locate the two self tapping
screws. Using an electric drill with a Phillips bit, screw them into
the cabinet at the marked location. Hang the module on the screws
using the mounting holes in the bracket
Note:
Do not cut any RO system tubes at this time
Hot
Cold
Supply
Supply
A
1/2" Confi guration
(Without Brass
Fittings)
Page 8
Black
Collet
White
Washer
Hot
Cold
Supply
Supply
Advertisement
Table of Contents
Troubleshooting
