Turn Signal / Side-Stand Relay; Diode Inspection - Suzuki GSX-R1000 Service Manual
Hide thumbs
Also See for GSX-R1000:
- Service manual (549 pages) ,
- Service manual (525 pages) ,
- Service manual (460 pages)
Table of Contents
Advertisement
Manuals by Motomatrix / The Solution For Lost Motorcycle Coded Keys
5) Connect the side-stand switch coupler.
6) Install the removed parts.
Turn Signal / Side-stand Relay
The turn signal/side-stand relay is composed of the turn
signal relay, side-stand relay and diode.
Side-stand relay
1) Remove the turn signal/side-stand relay. Refer to
"Turn Signal / Side-stand Relay Removal and
Installation" (Page 1I-7).
2) Check the insulation between "D" and "E" terminals
using the multi-circuit tester.
3) Apply 12 V to terminals "D" and "C" ((+) to "D" and (–
) to "C") and check the continuity between "D" and
"E". If there is no continuity, replace the turn signal/
side-stand relay with a new one.
Special tool
: 09900–25008 (Multi circuit tester set)
Tester knob indication
Continuity test (
)
"D"
"E"
SIDE-STAND RELAY
DIODE
"A"
"B" "C" "D" "E"
4) Install the turn signal/side-stand relay. Refer to "Turn
Signal / Side-stand Relay Removal and Installation"
(Page 1I-7).
email: info@motomatrix.co.uk / www.motomatrix.co.uk
I649G1190027-02
"C"
"B"
"A"
"F"
"G"
TURN
SIGNAL
RELAY
"F" "G"
I649G1190028-02
Diode inspection
1) Remove the turn signal/side-stand relay. Refer to
"Turn Signal / Side-stand Relay Removal and
Installation" (Page 1I-7).
2) Measure the voltage between the "A", "B" and "C"
terminals using the multi-circuit tester.
Special tool
: 09900–25008 (Multi circuit tester set)
Tester knob indication
Diode test (
)
"A"
"B"
"C"
+
"B",
"B",
"C"
"A"
0.4
–
NOTE
If the multi circuit tester reads 1.4 V and
below when the tester probes are not
connected, replace its battery.
3) Install the turn signal/side-stand relay. Refer to "Turn
Signal / Side-stand Relay Removal and Installation"
(Page 1I-7).
Gear Position Switch
1) Lift and support the fuel tank. Refer to "Fuel Tank
Removal and Installation" in Section 1G (Page 1G-
9).
Starting System:
"C"
"A"
"B"
I649G1190029-02
Probe of tester to:
"C"
"A"
1.4 V and more
(Tester's battery voltage)
0.6 V
I649G1190046-04
1I-8
- Quick Links:
- Table of Contents
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the GSX-R1000 and is the answer not in the manual?
Questions and answers
What should we change at the first service? After how many kilometers should the first service be done?
For the first service of a Suzuki GSX-R1000, the following should be changed:
- Engine oil
- Oil filter
This service should be performed initially at 1,000 km (600 miles, 2 months).
This answer is automatically generated