Checks After Engine Warm-Up; Shifting; Stop Switches - Yamaha F20B Owner's Manual

rious engine damage could occur.
Check the oil level and add oil if nec-
essary. Consult your Yamaha dealer
if the cause for the low oil pressure-
alert indicator cannot be found.
[ECM01830]
EMU36530

Checks after engine warm-up

EMU36540

Shifting

While tightly moored, and without applying
throttle, confirm that the engine shifts
smoothly into forward and reverse, and back
to neutral.
EMU36980

Stop switches

Turn the main switch to "
G
engine stop button and make sure the en-
gine stops.
Confirm that removing the clip from the en-
G
gine shut-off switch stops the engine.
Confirm that the engine cannot be started
G
with the clip removed from the engine
shut-off switch.
EMU34561
Shifting
EWM00180
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01610
NOTICE
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the
engine, shift to neutral, then restart the
engine and allow it to warm up.
To shift out of neutral
1.
1. Neutral interlock trigger
2.
", or press the
Pull the neutral interlock trigger up (if
equipped).
Move the remote control lever / gear
shift lever firmly and crisply forward (for
forward gear) or backward (for reverse
gear) [about 35° (a detent can felt) for re-
mote control models]. Be sure to check
that the tilt lock lever is in the lock/down
position (if equipped) before operating in
reverse.
Operation
ZMU05541
45