Setup Mode Programming - Cobra Marine MR HH350 FLT EU Owner's Manual

Main Icons

Setup Mode Programming

Operating Your Radio VHF Marine Radio Protocols
Intro Operation Customer Warranty
Assistance
Setup Mode Programming
Intro Operation Customer Warranty
The following series of procedures is designed to allow you
Assistance
to set the programmable features of your radio. Correctly
following these steps results in a minimal amount of radio
Customer
Installation
Assistance
setup programming time.
Customer
Installation
Secondary Icons Assistance
During setup programming, the matrix display will show text
Secondary Icons
describing the programming action you are now performing.
NOTE
When in the Setup mode, if you stop programming for
Notice Caution Warning
Notice Caution Warning
longer than 15 seconds, your entry will be saved and
the radio will go back to the Marine Standby mode.
When you return to Setup mode and continue
programming you will see the last "value" displayed.
While in the Setup mode, you will not receive any
signal reception except when setting squelch.
Marine (VHF) Mode Programming
Programming these features will allow you to customize
certain features of this radio to enhance your "On-Water"
Marine Standby Mode
radio use.
GMRS
VHF
R
X
Start from Marine Standby mode to begin Marine (VHF)
T
Setup programming. STANDBY will be displayed on the
A
B
U I C matrix. Press and hold the Call/Enter/Setup button for two
ATIS VOX LOMEDHI SAME MEM
(2) seconds to enter the programming mode.
The mode programming follows this sequence:
Squelch Level Set
I
UIC Channel Map
I
Tone Alert On/Off
I
Call Tone Select
I
Roger Beep On/Off
I
Key Tone On/Off
I
ATIS On/Off (displayed only when ATIS enabled)
I
16 English
Setup Mode Programming
VHF Marine Radio Protocols Operating Your Radio
Intro Operation Customer Warranty
Assistance
Squelch Control
Channel Up/Down Buttons
•
Squelch Control filters weak signals and radio frequency (RF)
noise so that you will clearly hear the signals you want.
FLOATING MARINE HH350
The Squelch Control on this radio is set through the following
Customer
Installation
Assistance
keypad operation.
CALL
Secondary Icons
To Set Squelch Control:
ENT SETUP
16/9
TW
1. With the power On, push and hold Call/Enter/Setup
MEM
button to access the Setup menu.
Squelch Control
2. Squelch control will be the first menu item to appear.
GMRS
Notice Caution Warning
VHF Press the Channel Up and Channel Down buttons to
R
X
set level. The signal level bar graph shows squelch
T
A level while you are in Setup mode on the squelch
B
U I C
adjust function.
ATIS VOX LOMEDHI SAME MEM
Main Icons 3. To adjust your squelch, press the Channel Down
button until you hear a hissing sound, then press
and release the Channel Up button until the hissing
stops. This will establish a "Baseline" squelch.
4. By pressing the Channel Up button further, you will
Intro Operation Customer Warranty
Assistance
filter weak and medium strength signals. By pressing
Channel Down button, you will receive weaker
signals.
Customer
Installation
Assistance
5. Press the Call/Enter/Setup button to save this entry
Secondary Icons and move to the next Setup mode programming.
NOTE
If the Squelch is set so that you can hear a continuous
Notice Caution Warning
hissing sound, the Memory Scan and Tri-Watch
functions will be blocked.
Nothing Comes Close to a Cobra ® 17