Do you have a question about the COFFEE BAR CF086 and is the answer not in the manual?
Questions and answers
Virginia S Jones
February 3, 2025
The brew basket won't reinsert into the base. Aline the the front slots- the back won't let the go all the way into the base. Putting the back of the brew basket into the back slot- the front is below the slots for it
1 comments:
Mr. Anderson
February 10, 2025
The brew basket may not reinsert into the base of the Ninja Coffee Bar CF086 if there are loose coffee grounds left in the basket, preventing it from sliding in properly. To fix this, remove and rinse the brew basket to clear any obstructions, then try reinserting it at a slight upward angle, similar to a cabinet drawer. Ensure it clicks into place securely.
43 Ounces 7 Do not let the power cord hang over the edge Euro-Pro and Ninja are registered trademarks of Euro-Pro Operating LLC. Ninja Coffee Bar is a of table or counter or touch hot surfaces trademark of Euro-Pro Operating LLC.
Page 3
8 Extension cords are not recommended for 18 Do not use a carafe having a loose or use with this product. weakened handle. 9 Do not remove the brew basket or carafe 19 Do not clean carafe with abrasive cleansers, while the appliance is brewing.
Page 4
FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and 2)This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
Contents Thank you for Getting To Know Your Ninja Coffee Bar ..................5 ™ Control Panel ..........................6 purchasing the Features Of The Ninja Coffee Bar ....................7 ™ Ninja Coffee Before First Use ........................8 Setting The Clock And Delay Brew ....................9 ™...
Getting To Know Your Ninja Coffee Bar ™ a Flip Top Water Reservoir Lid g Drip Stop Toggle b Removable Water Reservoir h Brew-through Carafe Lid c Brewer i Thermal Carafe d Control Panel j Multi-Serve Cup Platform e Permanent Filter...
Control Panel 1 Programmable Digital Clock 2 Clock Hour and Minute Buttons 3 Delay Brew Button 4 Multi-Serve Dial a Cup b Travel Mug c Half Carafe d Full Carafe 5 Brew Type a Classic Brew Button b Rich Brew Button c Over Ice Brew Button d Specialty Brew Button 6 Intelligent Clean Cycle Indicator/Button...
Drip Stop – Stops the flow of coffee from the brew basket allowing you to pour a cup mid-brew; switch toggle to the closed position to prevent dripping once the brew cycle is finished. • Clean Function – It illuminates when your Ninja Coffee Bar senses that there is hard water calcium buildup in your brewer which ™...
Before First Use PLEASE KEEP THESE IMPORTANT SAFEGUARDS IN MIND WHEN USING THE APPLIANCE: CAUTION: APPLIANCE CREATES HOT LIQUID. HANDLE WITH CARE. CAUTION: DO NOT remove the vessel while the appliance is running without the Drip Stop in the closed position. Return the vessel quickly and open the Drip Stop to continue the brew.
Delay Brew is set. side of the display as you are setting the time. (Fig. 2) The Delay Brew time is now set and your Ninja Coffee Bar ™ After 5 seconds the clock will stop flashing and the clock will will automatically brew at the time you programmed.
Assembly Fig. 4 Fig. 5 Fig. 6 Fig. 7 Fig. 8 Fig. 9 Place the brewer on a dry, clean and level surface. Once the brew basket is in place, slide all the way into place until you hear a slight click. Holding the water reservoir by the grip, twist counterclockwise to remove.
Preparing for Use CAUTION: Only fill water reservoir up to, but not exceeding the Max Fill line with water; we recommend fresh, cool, filtered water. Do not fill water reservoir with any other liquids such as brewed coffee, carbonated beverages, etc. as other liquids may damage your brewer. Fig.
(similar to a cabinet drawer). NOTE: Exceeding the recommended medium grind size for whole beans and 6 Ninja Carafe Scoops may cause the brew NOTE: Check for any loose grounds that may be left in the basket to overflow.
Stop to complete the brew. (Fig. 16) place. NOTE: If you forget to open the Drip Stop, the Ninja Coffee Use the multi-serve dial to select the size of coffee you will pause the brew, and after 20 seconds it will give ™...
Place the vessel that you would like to brew into carafe with ice and brew without the brew-through lid. underneath the brew basket. Press “Specialty Brew” The Ninja Coffee Bar will beep to signal a completed ™ and the brew will begin. (Fig. 20) Press the “Specialty brew.
™ recommended to keep your brewer brewing hot, rich, and smooth coffee. Fig. 21 The Clean button will illuminate when your Ninja Coffee Bar ™ CLEANING AFTER A BREW senses there is a calcium build up on your machine which may be affecting the flavor of your coffee.
If the Drip Stop is set to the closed, no drip position and the brewer continues to drip, run a clean after brew. cycle or wash the brew basket thoroughly with warm, soapy water. The Ninja Coffee Bar is designed to take a #4 cone filter. Be sure you are using this size and shape ™...
Page 18
Drip Stop once the vessel is placed under the brew basket. If the problem persists please call customer service at 1-877-646-5288. Why is the second cup Once the Ninja Coffee Bar has brewed the first cup, the brewing system is pre-warmed. ™...
Full Carafe Half Carafe How does the Ninja The carafe is designed to keep most of the coffee volume in the bottom so it can be held coffee bar keep closer to the Precise Temp Warming plate. This helps maintain the coffee at the ideal coffee at the right drinking temperature.
(as damage in shipping is not covered by your Limited Warranty). Mark the outside of your package “ATTENTION CUSTOMER SERVICE”. Product Registration lease visit www.ninjacoffeebar.com or call 1-877-646-5288 to register your new Ninja product within ten (10) ®...
Need help?
Do you have a question about the COFFEE BAR CF086 and is the answer not in the manual?
Questions and answers
The brew basket won't reinsert into the base. Aline the the front slots- the back won't let the go all the way into the base. Putting the back of the brew basket into the back slot- the front is below the slots for it
The brew basket may not reinsert into the base of the Ninja Coffee Bar CF086 if there are loose coffee grounds left in the basket, preventing it from sliding in properly. To fix this, remove and rinse the brew basket to clear any obstructions, then try reinserting it at a slight upward angle, similar to a cabinet drawer. Ensure it clicks into place securely.
This answer is automatically generated