Sanyo TA 4100 Operating Instructions Manual page 6

MOUNTING BRACKET
THUMB SCREW x
SPRING WASHER x 3
TAPPING SCREW x 3
----o
SO-239 ANTENNA SOCKET
MICROPHONE HANGER
ANTENNA PLUG (PL-259 type)
TO ANTENNA SYSTEM
RED WIRE (WITH IN-LINE FUSE HOLDER)
TO +12 VOLTS DC
TO EXTERNAL SPEAKER
Not Supplied
TO PA SPEAKER
Not Supplied
BROWN WIRE TO —12 VOLTS DC
4L
13. PA SPEAKER JACK — To use the Public Address function, you must
connect an external 8-ohm speaker (not supplied) to this jack. Use a
standard (3.5mmc5) miniature phone plug.
14. EXTERNAL SPEAKER JACK — Permits use of external 8-ohm speaker
(not supplied). Use a standard (3.5mmil)) miniature phone plug. When a
plug is inserted into this jack, the built-in speaker is automatically dis-
connected.
15. DC POWER SOCKET — Accepts power cable with in-line fuse for 12V
DC negative/positive operation. Insert the plug of power cable in this
jack. The Red wire with the in-line fuse must be connected to the + side
and the Brown wire to the — side.
MOBILE INSTAL I ATION
MOUNTING LOCATION
Safety and convenience are the primary considerations for mounting any
piece of mobile equipment. All controls must be readily available to the
operator without interfering with the movements necessary for safe operation
of the vehicle. Be sure all cables are clear of the brake, clutch and accelerator.
The most common mounting position for a transceiver is under the dashboard
directly over the transmission hump. See illustrations for UNDER-DASH
MOUNTING.
All mounting brackets and hardware are supplied with this transceiver.
UNDER-DASH MOUNTING