Summary of Contents for Windsor Dominator 17 NMWU2215N
Page 1
Dominator 150 PSI - 17 gallon Extractor Operating Instructions (ENG) MODELS: NMWU2215N 10066700 From Serial Number (Ref No. 1*) * See Serial number page or call manufacturer. 86399190-A 01/02/15...
Machine Data Label Overview The Dominator is an electric powered carpet extractor intended for commercial use. This appliance applies a cleaning solution to the carpet and then vacuums the soiled water back into the recovery tank. Warranty Registration Thank you for purchasing a Kärcher North America product. Warranty registration is quick and easy.
How To Use This Manual This manual contains the following sections: The SAFETY section contains important information regarding hazardous or unsafe practices of the • How to Use This Manual machine. Levels of hazards are identified that could • Safety result in product damage, personal injury, or severe •...
Safety IMPORTANT SAFETY INSTRUCTIONS When using this machine, basic precaution must always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS MACHINE. To reduce the risk of fire, electric shock, or injury: Connect to a . See Grounding Instructions. properly grounded outlet leave the machine unattended.
Safety The following symbols are used throughout this guide as indicated in their descriptions: HAZARD INTENSITY LEVEL There are three levels of hazard intensity identified by signal words -WARNING and CAUTION and FOR SAFETY. The level of hazard intensity is determined by the following definitions: WARNING - Hazards or unsafe practices which COULD result in severe personal injury or death.
Safety Safety Labels NOTE: These drawings indicate the location of safety labels on the machine. If at any time the labels become illegible, promptly replace them. 86399190 Operators Manual - Dominator 150 psi 17 gallon...
Safety Grounding Instructions Grounding Pin THIS PRODUCT IS FOR COMMERCIAL USE ONLY. GROUNDING CONNECTION USING AN ADAPTOR Grounded Grounded Outlet Box ELECTRICAL: Adaptor Outlet FIGURE A In the USA this machine operates on a standard 15 amp 115V, 60 hz, A.C. power circuit. The amp, hertz, and voltage are listed on the data label found on each Metal Screw machine.
Operations Machine Operation Only use chemicals approved for use with this machine. Use of non-compatible chemicals may cause machine damage and will not be covered under the warranty. Carefully read ingredients on manufacturer's Care must be exercised in the use of all chemicals. label before using any product in this machine.
Operations Pre-Run Inspection Cleaning 1. Check all fittings and connectors for proper assembly. Always use defoamer if foaming occurs. Foam will 2. Check all hoses for leaks. Repair or replace any suspend large particles that may damage damaged hoses. vacuum(s) as well as allow liquid into the vacuum 3.
Maintenance Periodic Maintenance Daily/Regular Maintenance Twice a month, flush a white vinegar solution (one quart vinegar to two gallons of water) or anti-browning solution (mixed as directed) through the machine. This Before making any repairs or adjustments to the will prevent build-up of alkaline residue in the system. machine, disconnect the power cords from the If spray jets become clogged, remove the spray tips, electrical source.
Maintenance Vacuum Motor Carbon Brushes Replacement Only qualified maintenance personnel are to End Cap perform the following repairs. Vacuum Motor Replacement Carbon 1. Turn off all switches and unplug machine. Brushes 2. Remove hardware under front of machine to access component compartment. WARNING: The green ground wire 3.
Maintenance Troubleshooting PROBLEM CAUSE SOLUTION Unit not plugged in Connect unit to 3 prong grounded outlet. Loss of Power Dead electrical circuit Check building circuit breaker or fuse box. Faulty power cord Replace Receptacle not grounded Contact an electrician to check building's wiring Electrical shock Have a trained service technician check Internal wiring problem...
Need help?
Do you have a question about the Dominator 17 NMWU2215N and is the answer not in the manual?
Questions and answers