Positioning The Appliance In The Wall Housing Unit - Miele DA 3460 Operating And Installation Instructions

Positioning the appliance in
the wall housing unit
To position the appliance correctly,
cut the spacer strip to the required
depth T, and then attach it to the
back of the appliance.
T= Wall unit depth K minus depth of
appliance G
^ Example a shows installation without
a lightshield and the front edge of the
pushed in deflector plate is aligned
with the front of the wall housing unit.
^ Example b shows installation with a
lightshield to blend in with
surrounding kitchen furniture. The
installation position is adjusted by the
thickness b of the front panel plus
5 mm for the bracket DML 400.
^ Cut the spacer strip supplied to
measurement T.
Score along the groove for the
smaller measurement as shown, and
remove the surplus.
^ Screw the spacer strip to the bottom
of the sides of the housing, flush with
the rear wall.
^ Draw a vertical line up both inside
walls of the housing from the front of
the spacer strip.
Installation
25