Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Redcat Racing EARTHQUAKE 8E
Summary of Contents for Redcat Racing EARTHQUAKE 8E
- Page 3 Special symbols Please pay attention to the following symbols, and read them carefully. If the operator does not operate according to the instructions, it may lead to Danger: serious injuries, even mortal danger. If the operator does not operate according to the instructions, it may lead to Warning: serious injuries, even mortal danger.
-
Page 4: Battery Charging
Battery charging If your transmitter, receiver use a nickel-cadmium, nickel-metal hydride rechargeable battery, you have to check it before use. If lack of electricity, it could cause inadequate control or out of control, resulting in accident. So please charge it immediately when the battery power is low. - Page 5 Note: Place the antenna of the receiver vertically with the truck! Don't put it close to the metal thing for assuring its sensitivity.(See Figure Receiver Figure 1 2.4G Operation notes Matching (code) The transmitter and the receiver are well matched in the factory, you do not need to match them. But if you are going to match the receiver with another transmitter, or you need to change a new receiver or transmitter,please follow these steps:...
- Page 6 Connecting to the power .Connect every part. .Switch on the power supply of the transmitter. .Connect the power supply of the receiver. .Receive LED light solid. .Finish and use. Power on Tx power ON Rx power ON Shut down： A.Cut off the receiver power supply. B.Cut off the transmitter power supply.
- Page 7 Transmitter function notes Function Introduction: This function is to control the direction, when the steering turn to right then the front wheel will turn to right (as picture), when the steering turn to left then the front wheel will turn to left (as picture). Operation Method: Adjust the dual rate of the steering by adjusting the D/R knob.
- Page 8 B7054...
-
Page 10: Parts List
PARTS LIST Item No. Description Item No. Description BS903-089 Pin(2*9.5) 12pcs BS808-001 Axle w/pin 2pcs BS903-091 Washer A(5.2*10*0.2) 12pcs BS808-002 Rim hub w/pin2*10 4pcs BS903-092 Washer B(4.2*8*0.2) 12pcs BS808-003 M5 locknut 6pcs BS903-094 Double way ball end 6pcs BS808-004 Centre diff.Unit BS903-095 (M4*4) Set Screw 6pcs BS808-005 Spur gear(49T) BS903-097 Diff. - Page 11 2.4GHz...
- Page 12 BS701-041 Pin 1.2 6 pcs...
- Page 13 2.4GHz...
- Page 14 MPO-019 Metal Spur Gear(49T)
Need help?
Do you have a question about the EARTHQUAKE 8E and is the answer not in the manual?
Questions and answers