Epson PowerLite 570 Quick Setup page 2

Camera, USB device, or document camera
Connect a digital camera, USB flash drive, USB storage device, or Epson DC-06
document camera to the projector's USB-A (flat) port.
Using the remote control
Make sure the batteries are installed as shown (two AA batteries).
Turn projector
on and off
Access projector
menus
Change presentation
slides (USB only)
Turn off projector
display and sound
For more information on using the remote control, see online User's Guide.
Turn on your equipment
1
Turn on your computer or video source.
2
Make sure the power cord is connected and plugged into an
electrical outlet.
Status light
3
Press the power button on the projector or remote control. The
projector beeps, and the Status light flashes blue and then stays on.
Note: To shut down the projector, press the
4
If you don't see an image, press the Source Search button on the
remote control to select the image source.
Note: If you still see a blank screen or have other display problems, see
the troubleshooting tips on the back of this sheet.
Choose which
source to display
Navigate projector
menus
Control projector
volume
Get solutions to
common problems
power button twice.
5
If you need to focus the image, first slide the switch on the side of the
projector to open the air filter cover. Then raise or lower the focus lever
to sharpen the image.
6
The default language of the menu system is English. To select another
language, press the Menu button on the remote control. Select
Extended and press . Select Language and press
language and press . Press the Menu button to exit the menu system.
Project over a wired
network
If you need to configure the projector for your network, see "Network
Configuration" on the back of this sheet.
1
Press the LAN button on the remote control. You see this screen.
2
Start EasyMP ® Network Projection on your computer.
Windows 8: Navigate to the Apps screen and select EasyMP Network
Projection.
Other versions of Windows: Select
Programs > EPSON Projector > EasyMP Network Projection.
OS X: Double-click the EasyMP Network Projection icon in the
Applications folder.
3
Select Advanced Connection Mode and click OK.
4
Select the projector you want to connect to, then click Connect.
If you don't see the projector you want, click the Automatic search
button.
5
If you see a message asking for a keyword, enter the four digits that
appear on the LAN standby screen and click OK.
Your computer image is projected, with a floating toolbar:
When you're done presenting, click Disconnect on the toolbar.
Note: To project wirelessly, you need the optional wireless LAN module.
For more information about using the projector on a network, see the
online User's Guide.
. Select your
or Start > Programs or All