Icom IC-7200 Quick Reference Manual

IC-7200
HF/50 MHz
TRANSCEIVER
Quick Reference Manual
1. PASSBAND TUNING CONTROLS [TWIN PBT] Adjust the receiver‟s DSP filter passband width.
• The limit of the variable range depends on the passband width and mode. The limit of the variable range is half of the passband width,
and PBT is adjustable in 200 Hz (AM) or 50 Hz (other models) steps.
• Rotate both [TWIN PBT] controls (PBT1 and PBT2) to
the same position shifts the IF.
[NB]
2. NOISE BLANKER KEY
➥ Push to turn the noise blanker function ON or OFF.;
appears on the display.
➥ Push and hold for 1 sec to enter the noise blanker set mode for setting the noise blanker level and return to normal
operation.
• When entering the noise blanker set mode, the noise blanker function is automatically turned ON.
[NR]
3. NR KEY
➥ Push to turn the noise reduction function ON or OFF.;
appears on the display.
➥Push and hold for 1 sec. to enter the noise reduction level set mode; push again to return to normal operation.
• When entering the noise reduction set mode, the noise reduction function is automatically turned ON.
[ANF]
4. ANF/METER KEY
METER
➥ Push to turn the Automatic Notch Filter function ON or OFF.;
appears on the display.
➥ Push and hold for 1 sec. to toggle the meter function:
PO ➟ SWR ➟ ALC
• PO : indicates the relative RF output power.
• SWR : indicates the SWR over the transmission line.
• ALC : Indicates ALC level.

5. KEYPAD

6. RIT CONTROL INDICATOR

Lights orange when [M-CH] control (7) acts as the RIT control.
7. M-CH/RIT CONTROL [M-CH] (inner control)
➥ While in the set mode/quick set mode, rotate to select the set mode item.
➥ This control can act as the memory channel control or RIT control.
• The RIT function should be turned ON in advance to activate this control as RIT control.
- appears when the RIT function is turned ON.
• The RIT control indicator (6) lights orange when this control is activated as the RIT control.
➥During [M-CH] acting as the M-CH control:
•
Rotate to select a memory channel.