Table of Contents
Advertisement
Quick Links
3.2. INSTALLING THE OPERATOR
7. SPECIAL APPLICATIONS
9. REPAIRS
CE DECLARATION OF CONFORMITY FOR MACHINES
Manufacturer:
GENIUS S.p.A.
Address:
Via Padre Elzi, 32 - 24050 - Grassobbio- Bergamo - ITALY
Operator mod. MILORD 5 - MILORD 8 - MILORD 424
Declares that:
•
is built to be incorporate in a machine or to be assembled with other machinery to create a machine under the provisions of Directive 98/37/EC;
•
conforms to the essential safety requirements of the other following EEC directives:
73/23/EEC and subsequent amendment 93/68/EEC.
89/336/EEC and subsequent amendment 92/31/EEC and 93/68/EEC
Furthermore, the manufacturer declares that the machinery must not be put into service until the machine into which it will be incorporated or of which
it will become a part has been identified and its conformity to the conditions of Directive 98/37/EC has been declared.
Grassobbio, 01-06-2006
The symbol
indicates notes that are important for the safety of persons and for the good condition of the automated system.
The symbol
INDEX
(DIRECTIVE 98/37/EEC)
Notes on reading the instruction
Read this installation manual to the full before you begin installing the product.
draws your attention to the notes on the characteristics and operation of the product.
Managing Director
D. Gianantoni
6
page.7
page.7
page.7
page.7
page.7
page.8
page.9
page.0
page.0
page.0
page.0
page.0
page.0
Advertisement
Table of Contents
Related Manuals for Genius MILORD 5
Summary of Contents for Genius MILORD 5
- Page 1 9. REPAIRS page.0 CE DECLARATION OF CONFORMITY FOR MACHINES (DIRECTIVE 98/37/EEC) Manufacturer: GENIUS S.p.A. Address: Via Padre Elzi, 32 - 24050 - Grassobbio- Bergamo - ITALY Operator mod. MILORD 5 - MILORD 8 - MILORD 424 Declares that: • is built to be incorporate in a machine or to be assembled with other machinery to create a machine under the provisions of Directive 98/37/EC;...
- Page 2 MILORD AUTOMATED SYSTEM The MILORD automated system for residential sliding gates is an electro- 2. ELECTRICAL SET-UP mechanical operator which transmits motion to the leaf through a pinion (standard system) gear suitably coupled to a rack fitted on the gate. The non-reversing system ensures mechanical locking when the motor is not operating and, therefore, installing a lock is unnecessary.
- Page 3 Wall in the plate perfectly levelled. Wait for the cement to set in the cavity. Lay the electrical cables for connection to the accessories and the electrical power supply (paragraph 2). To facilitate making the electrical connections on the control unit, make the electric cables protrude by about 20 cm from the hole on the foundation plate.
- Page 4 To obtain correct play between rack and pinion, lower the gearmotor by 1.5 mm, using the nuts supporting the foundation plate. When you have finished adjusting, correctly tighten the operator securing nuts. If the gate was recently built, check this play (fig.2) a few months after installation.
- Page 5 Fig. 15 The User must not in any way attempt to repair or to take direct action and must solely contact qualified GENIUS personnel or GENIUS service centres. 5. AUTOMATED SYSTEM TEST Check operating efficiency of the automated system and all accessories connected to it.
Need help?
Do you have a question about the MILORD 5 and is the answer not in the manual?
Questions and answers