Configuration - Teltonika FM5300 User Manual

 SCAN scans once for available messages on CAN bus;
 Monitoring – toggles scanning of messages on CAN bus every 3 seconds;
 Offline Configuration – enables CAN configuration when FM53xx is not connected to CAN
bus;
 Auto CAN tab – configure CAN by selecting available messages from CAN bus;
 Manual CAN tab – Configure CAN by manually entering CAN message ID and data mask;

Configuration

To start CAN configuration push "SCAN" button. A table of all available CAN
messages will appear (Fig. 63). Description of columns:
 Category – shows CAN message;
 Parameter – shows configurable parameter name;
 Value – shows scanned value of parameter;
 Send data to server – allows to choose the type of data when it's generated:
o Disabled – Data will not be collected
o On low priority – records will be generated as low priority events;
o On high priority – records will be generated as high priority events and immediately
sent to server via GPRS (if GPRS is available);
o On panic - records will be generated as panic priority events and immediately sent
to server via GPRS, if GPRS is not available records will be sent via SMS messages;
 Data acquisition type – allows to choose when records are generated:
o Monitoring – monitors data;
o On change – record is generated when parameter value is changed;
o Hysteresis – record is generated when increasing parameter value becomes higher
than High value, and decreasing becomes less than Low value
Figure 61 Entering CAN configuration
Figure 62 CAN configuration menu
83