Broncolor Minipuls C200 Operating Instructions Manual

Hide thumbs Also See for Minipuls C200:

Advertisement

Operating instructions
minipuls C200
www.broncolor.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Minipuls C200 and is the answer not in the manual?

Questions and answers

Summary of Contents for Broncolor Minipuls C200

  • Page 1 Operating instructions minipuls C200 www.broncolor.com...
  • Page 2: Table Of Contents

    Keep these operating instructions in a safe place and pass them on to further users if necessary. Observe the safety instructions. Contents page Safety information Controls and displays Front panel for Minipuls C200 Minipuls C200 Application Commissioning Flash tube Protecting glass Modelling light...
  • Page 4: Safety Information

    Even when disconnected from power, dangerous voltages may remain within the interior of the device. For this reason, devices should only be opened by our broncolor repair service. For safety reasons, never operate a unit without the protecting glass in place.
  • Page 5: Controls And Displays

    Controls and displays Flash release key Jack for synchronous cable Flash ready control lamp Connection socket for mains cable Fuse Switch for modelling light (proportional/full) Switch for modelling light (on/off) Main switch (on/off) Slave cell (on/off) 10. Infrared receiver (on/off) 11.
  • Page 6: Front Panel For Minipuls C200

    Front panel for Minipuls C200...
  • Page 7: Minipuls C200

    Minipuls C200 We are delighted that you have chosen the high quality product broncolor Minipuls C200. With proper care it will render you many years of good service. Application This mains supplied studio flash unit is designed for professional photography only. In countries with earthed mains systems, use a three- wire extension cable.
  • Page 8: Flash Tube

    The spring acts as the electrical contact and also prevents the tube from falling out. For Minipuls C200 following 1500 J flash tubes are available. coating for 5500 K art. no.
  • Page 9: Afterglow Block

    The enclosed locking pin has to be screwed into the lower part of the ® stand adapter so it can be hung from a broncolor bolt; this is not required for stand mounting. A safety cable must be installed whenever the lamphead is suspended.
  • Page 10: Accessories

    When in use, make sure that the receiver cell of the unit is not blocked by obstacles. Accessories The Pulso bayonet system allows you to use the full line of broncolor reflectors. For a complete summary, please consult the broncolor system catalogue, "Be Creative with Light. And with System."...
  • Page 11: Technical Data

    Minipuls C200). Subject to change in the interest of technical development. Order numbers for diverse spare parts/accessories flash tube 5500 K for Minipuls C200 art. no. 34.310.55 halogen modelling light (650 W / 240 V) art. no. 34.226.XX halogen modelling light (300 W / 120 V) art.

Table of Contents