Assembly - NordicTrack C2 Si User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the exercise cycle, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-
assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M4 x 16mm
Screw (58)–11
M8 Locknut M10 Split M10 Curved
(57)–6 Washer (63)–4 Washer (10)–4
M8 x 35mm Button
M6 x 10mm M8 x 56mm Button
Bolt (64)–4
Button Screw
Screw (61)–2
(60)–2
M10 x 85mm Patch
M10 x 25mm Patch
Screw (56)–4
Screw (46)–4
5