Switch On The Monitor; Register The Sensors - Tyrepal TC215/OEK User Manual

4.1 Switch on the monitor

The monitor is powered from an internal rechargeable battery that is
normally supplied with some charge.
If the display does not appear, connect it to the vehicle power supply
(12V to 24V) to charge the battery. It is not harmed by a partial charge.

4.2 Register the sensors

These instructions refer to pre-fitted internal sensors (TyrePal TPMS Ready wheels). If you have additional
external sensors for the tow car or for spare wheels, please see the separate instructions for registering them.
1. In standby mode, press and hold the CODE button for 3
seconds. Release it after the beep to enter coding mode.
2. The display shows one tyre icon flashing and a series of numbers
and letters which are the ID of the sensor registered to that tyre
position. If no sensor is registered to that position, the display
will be FFF FFF .
3. Press the + or – button to scroll through the tyre positions and select the desired tyre position. Place the
monitor close to the tyre valve and press the CODE button briefly once more, but do not hold it down.
The LF icon flashes and the red light shows on the monitor.
4. On receiving the code, the monitor gives a long beep and the tyre position is stored together with the
sensor ID. The tyre icon continues to flash after the code is received.
5. If the monitor does not receive the code within 6 seconds, an error message ERR is displayed, a double
beep is given and the red light goes out. Move the monitor closer to the tyre valve and repeat steps 3
and 4.
6. Press + or – buttons to select the other tyre positions and repeat for all the internal sensors that are to
be registered.
7. When all sensors are registered, press and hold the CODE button to exit. If you don't compete this
step, the registrations are not saved.
If you need to delete a setting, use the + or – buttons to select the tyre position then press and hold the SET
button for three seconds. A double beep confirms the ID has been deleted.
Note: If a sensor is coded twice to the same monitor, the previous setting will be deleted automatically.
6