Table of Contents
Advertisement
To assign a title using the buttons on the main unit
26
Assigning the disc title and track
titles
You can assign a title to each MD and to each track. Once a title is assigned, it is displayed
for later playback for confirmation.
Each title can be composed of up to 64 characters, and can be input using alphabetic
characters — uppercase (A to Z) and lowercase (a to z), symbols (see "Available symbols"
on the next page), and numerals (0 to 9).
In the following example, the process is explained from the very first — that is, inserting an
MD. If you already start recording or playing, see "To assign a track title during playback
or recording" on page 29.
1 Load a recorded MD.
2 Press TITLE.
The display will show "DISC/NO TITLE".
Each press of the button switches the title assignment function on and off.
•
If a disc title has already been assigned, the title is displayed.
When you assign the disc title: Go to step 3.
When you assign the track titles:
First select the track to be titled by turning the jog
dial to the right or left. Then, go to step 3.
3 Press SET.
The title assignment display appears.
The display is divided into the title name area and the character set area.
4 Enter a character.
Example: When entering character "n".
1
Press DISPLAY/CHARACTER repeatedly.
Each press of the button changes the character sets as follows:
Capital letters
2
Turn the jog dial until "n" blinks on the character set area.
•
Turning the jog dial continuously can also change the character sets.
3
Press SET.
The selected character is entered, and the cursor moves to the next character entry
position.
Title name area
Small letters
& Symbols
Numerals
Scrolls
Blinks
Blinks
Scrolls
Cursor
Alternately blinks
(blinks)
Character set
area
& Symbols
Advertisement
Table of Contents
