Charging Controller; Switch On/Off The Controller; Connect The Pc; Attention - iPega PG-9023 User Manual

About input method seting: Using the controller to play game should set the phone or notebook input method to be default as English
language input (For the ios system, be sure to switch the input method, and then pairing. If not, the handle does not work properly.)
Charging controller: Accessing the controller to 5V power supply for charging (PC device or mobile phone power adapter).
of charging, the charge indicator light of handle is orange and LED is off after
Switch on/off the controller: Press "HOME" button for 3 seconds until the Bluetooth LED is off, it means shutdown is successful. If the
phone is not unpair connection when controller shutdown. Just do it again
Press the "HOME" button for about five seconds, until the LED red light flashes slowly. It means that the handle is turned on (the default
the last boot mode), the boot handle will automatically paired with the phone connection. If the connection fails, the handle will
automatically shut down.
Connect the PC: Open the device's Bluetooth PC program, and select the "X, A" in either mode can be paired with(and does not have
a Bluetooth PC devices need to use the Bluetooth receiver).
Note: To change the controller function mode, please turn off the controller firstly and cancel the bluetooth pairing , then in accordance
with the operation mode to replace the steps.

Attention

1. When the controller can't operate normally, please use the papperclip to touch the reset switch on the left corner of the grip back when
the grip cannot shut down or crash.
2. Please do not put this product in wet or hot place for storage.
3. Do not hit, beat, piercing or attempt to disassemble the product to avoid unnecessary damage.
the built-in battery
4. Do not discard
5. Do not use near fire or other heat source to recharge the battery.
with garbage.
fully charged.
In the process