Multi Position Saddle - Rifton K640 Product Manual

Multi-position saddle
To prevent falling and
WARNING
resulting injury, the
hip corral strap should be used for all
non-weight-bearing clients, or any time
added security is needed.
Attaching (see fi gure 25a)
• To attach saddle
press button (B) and insert saddle
upright into recess under cross bar.
• To remove saddle
(A) and safety button (B).
Adjustments (see fi gure 25b)
• To adjust height
• To adjust seat angle
• To adjust seat forward or backward
press trigger (E).
• To adjust hip corral in or out,
attach or remove it, press trigger (F).
fi rst remove hip corral,
• To remove seat
then slide seat using trigger (E) as far
back as possible. Finally, press 2 buttons
on each side (G) to complete removal.
• To adjust hip corral height
trigger (H).
• To attach corral strap
rear of seat. The corral strap as well
as the pads on the hip corral can be
removed, if desired. To remove pads,
undo hook and loop patch between
pads and slide pads off bar. To detach
corral strap, remove pads, then press
small white buttons near end of bar and
pull rings from slots.
Tip: Every white lever or button
indicates a point of adjustment.
under upper frame
press both button
press trigger (C).
press button (D).
or to
press
clip hook onto
A A
B B
A A
Figure 25a
F F
G G
Figure 25b
B B
H H
E E
D D
C C
25