Table of Contents
Advertisement
Assembly
Fold/Unfold the treadmill
Fold: Hold the end of the running deck, by the side frames/
rails, and lift it until the machine gets an upright position and
you hear a click from the security lock clasp.
Unfold: Press the security lock clasp with your foot. Push
the running deck down, holding it by the side frames. The
running deck will go down slowly thanks to the hydraulic
system.
Set up options
Time display range
Distance range
Pulse display range
Calorie display range
Maximum user weight
Programs
Incline range
Speed range
Speed direct choice
Speaker
Music
When starting the treadmill
Stand on the side frames.
Do not stand on running belt.
10
0:00 - 99:59
0 - 9.999 km/mls.
Total distance memory
50 - 230 bpm
0 - 999 Kcal
160kg, 25.2st
30 automatic programs
0 - 16%
1 - 20 km/h
(0.62 - 12.43 mph)
3, 8, 16km/h
High-fidelity stereo speaker
MP3, USB audio interface (USB
also charges Apple devices) and
Bluetooth connection
Use the following instructions to set
up the units settings
Insert the safety key into the corresponding socket.
1. Without anyone on the treadmill, plug the power cable.
2. Switch on the treadmill. Power switch is under the front
end of the machine. The control panel will light up and all
the figures in the window will go to ZERO.
3. Introduce the weight that you can see flashing on the
right side of the screen using the SPEED button.
4. Press the START button and the motor will work at the
speed
of 0.3 km/h.
5. Press the FAST and SLOW
button to increase or decrease the speed.
6. Press the UP and DOWN button to increase or decrease
the incline.
7. Press the STOP button to stop the machine.
8. Put music in MP3 format into USB flash drive and insert it
into the USB socket. On the treadmill press PLAY/PAUSE to
play the music. Change the track with SOUND-/LAST and
SOUND+/NEXT buttons. To adjust the volume, press and
hold SOUND-/LAST or SOUND+/NEXT buttons.
9. See page 16 for bluetooth operation guide.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Atmos Pro and is the answer not in the manual?
Questions and answers
Hi. My treadmill stopped working. The display is flushing but no buttons are reacting. It has been moved recently and arms were disconnected and connected back. Since then is only flashing
If your Kettler Atmos Pro treadmill display is flashing and not responding after being moved, try the following steps:
1. Check the Safety Key – Ensure the safety key is properly inserted in the console, as the treadmill will not start without it.
2. Power Cycle the Treadmill – Unplug the treadmill from the power source, wait for 10 minutes, then plug it back in.
3. Inspect for Damage – Check if the treadmill was dropped or damaged during the move.
4. Perform a Quick Start/Stop Reset – Press the STOP button and ensure all screen displays reset to zero.
5. Check Electrical Connections – Ensure all cables are securely connected and not near heated surfaces or sharp edges.
If the issue persists, contact Kettler service personnel for further assistance.
This answer is automatically generated