The appliance should only be used as described in this user guide. Only Vax recommended attachments should be used with this appliance. Do not use this vacuum cleaner if it has been dropped, damaged, left outdoors or dropped into water.
Page 5
IMPORTANT: If the inlet, hose or tube is blocked, switch off the vacuum cleaner and remove the blockage(s) before re-starting the vacuum cleaner. IMPORTANT: Vax recommends the use of Residual Current Device Rating of 30mA or less. IMPORTANT: It is very important that filters are kept clean to obtain maximum performance from your vacuum cleaner.
Getting started PLEASE READ SAFETY INFORMATION BEFORE USE (PAGE 4 & 5 ) Assembling your upright Using a crosshead screwdriver, Slide the handle down onto the Return the screw and tighten, remove the screw from the back of main body of the unit. securing the handle into the main the unit as shown.
fl oor position when using this cleaner on lino and hard fl oors due to constant rotation. Vax cannot be held responsible for damage to these surfaces if the consumer fails to take notice of this recommendation.
How to use Using the accessories IMPORTANT: When the vacuum cleaner is stood in the upright position, or when using the hose and tools, the brush bar height adjust must be set to the highest position. Pull out the lower hose from the Choose an accessory, then attach to lower hose connector.
Cleaning the separator Turn the lid of the dirt container Wipe the separator with a cloth to anticlockwise to remove. remove any dirt. vax.com.au vax.co.nz...
IMPORTANT: It is very important to keep the fi lter clean to maintain maximum performance of the vacuum. Vax recommends that your fi lter should be checked for cleanliness and cleaned accordingly after each use in addition to being washed and replaced on a regular basis (every 3 months depending on the level of use).
Page 11
Next, remove the belt from screwdriver as indicated by arrows. the brushbar and from the motor spindle towards the rear of the fl oor head. Replace the belt. vax.com.au vax.co.nz...
FAQs WARNING: to reduce the risk of personal injury, unplug the vacuum cleaner before performing maintenance/trouble shooting checks. Why won’t the vacuum cleaner turn on? • It may not be plugged into the electrical socket correctly; ensure that the plug is pushed in securely. • T he electrical socket may not be working properly; check the fuse or breaker, or consult an electrician. • T he motor thermostat may have tripped; switch off and unplug the vacuum cleaner, and leave for one hour before switching the cleaner back on. Why won’t the vacuum cleaner pick up? • T he dirt container may be incorrectly installed; remove the dirt container from the unit by pressing the dirt container release button and then re-attaching it to the unit, ensuring it is locked firmly back...
Other information Service & Help Any queries or concerns about using your Vax, simply visit; vax.com.au / vax.co.nz or, call the Vax Careline. Calls are charged at the standard local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling. Vax Careline:...
Need help?
Do you have a question about the White and is the answer not in the manual?
Questions and answers