Utax 2550ci User Manual page 414

NOTE:
By default, one of each default user with machine administrator rights and administrator privileges is
already stored.
Each user's properties are:
Machine Administrator
User Name: DeviceAdmin
Login User Name: 2500
Login Password: 2500
Access Level: Machine Administrator
Administrator
User Name: Admin
Login User Name: Admin
Login Password: Admin
Access Level: Administrator
* Upper case and lower case letters are distinguished (case sensitive).
It is recommended to periodically change the user name, login user name and login password regularly for
your security.
Use the procedure below to register a new user.
User:
User Name:
Change
01 User
Login User Name: Change
0099
Access Level:
Change
User
E-mail Address: Change
abcd@efg.com
Local Authorization: Next
Status
Login Password: Change
**********
Account Name:
Change
02 Account
ID Card Information: Change
Empty
Cancel Save
12/12/2011 10:10
1
Login as a user with administrator rights.
2
Press the System Menu key.
3
Press [User Login/Job Accounting].
4
If the user authentication screen appears, enter
your login user name and password and then press
[Login]. For this, you need to login with
administrator privileges. The login user name and
login password are both set to "2500" in the factory
default state.
5
Press [Next] of User Login Setting, [Add/Edit] of
Local User List, and then [Add].
6
Press [Change] of User Name.
7
Enter the user name and press [OK].
NOTE:
Refer to the Character Entry Method on
Appendix-6 for details on entering characters.
8
Enter the login user name and E-mail address
following 6 and 7 above.
9
Press [Change] of Login Password and then
[Password].
10-6
Management