Table of Contents
Advertisement
Use compact discs bearing the symbol shown
below. In addition to conventional 12 cm CDs,
this system can be used to play 8 cm CDs
without an adapter.
1. Set the FUNCTION switch to CD.
2. Press the CD compartment lid (OPEN/
CLOSE portion) to open it.
3. Place the disc with the label facing up on
the turntable. (Place only one disc at a time.)
Label facing up
4. Press the CD compartment lid (OPEN/
CLOSE portion) to close it.
The total number of tracks on the disc ap-
pears on the display.
5. Press the i button.
The current track number appears. Play
starts from the first track.
•
To start play from the desired track, se-
lect the track by using the f or e
button, then press the i button.
Note:
If no disc is loaded, "no" appears. If the disc
is loaded with the label facing down "Er"
appears. If these occur, load the disc cor-
rectly or replace the damaged disc.
CD PLAY
6. Press the n button to end disc play.
When the last track has been played, the
player stops automatically.
7. To turn the CD player off, set the FUNCTION
switch to TAPE/OFF.
Note:
Do not open the CD compartment during CD
play. Always press the n button and wait for the
disc to stop rotating before opening the CD
compartment.
This unit can play back the CD-R/RW as well.
However, some CD-R/RWs can not be played
back depending on the recording conditions.
Notes on handling compact discs
•
Do not expose the disc to direct sunlight,
high humidity or high temperatures for ex-
tended periods of time.
•
Discs should be returned to their cases af-
ter use.
•
Do not apply paper or write anything on the
disc surface.
•
Handle the disc by its edge. Do not touch
the playing surface (glossy side).
•
Fingerprints and dust should be carefully
wiped off the playing surface of the disc with
a soft cloth.
Wipe in a straight motion from the center to
the outside of the disc.
•
Never use chemicals such as record clean-
ing sprays, antistatic sprays or fluids, ben-
zene or thinner to clean compact discs.
Temporarily stopping play
Press the i button, The current track number
blinks on the display. To resume play, press the
button again.
Skip play
To skip to track 6 while track 3 is playing, press
the e button repeatedly until "06" appears on
the display. To skip back to track 3 while track 6
is playing, press the f button repeatedly until
"03" appears.
Search (forward/reverse)
If the e or f button is pressed during play,
the player will search at high speed in the for-
ward or reverse direction while the button is
being pressed. When the button is released,
normal play will continue.
4
Advertisement
Table of Contents
