Important Safety Instructions For All Battery Packs - DeWalt DCR006 Instruction Manual

• The label on your tool may include the following symbols. The
nameplate label is located on bottom of unit. The symbols and
their definitions are as follows:
V ................... volts
Hz ................. hertz
min ............... minutes
or DC ... direct current
................. Class I Construction
..................... (grounded)
................. Class II Construction
(double insulated)
.../min .......... per minute
BPM ............. beats per minute
IPM ............... impacts per minute
RPM ............. revolutions per
minute
sfpm ............. surface feet
..................... per minute
SPM ............. strokes per minute
Important Safety Instructions for All
Battery Packs
When ordering replacement battery packs, be sure to include the
catalog number and voltage. Consult the chart at the end of this
manual for compatibility of chargers and battery packs.
The battery pack is not fully charged out of the carton. Before using
the battery pack and charger, read the safety instructions below and
then follow charging procedures outlined.
READ ALL INSTRUCTIONS
Page dimensions: 8.5 x 5.5 inches
A ......................amperes
W .....................watts
or AC ..........alternating
current
or AC/DC ...alternating
........................or direct
current
n o ....................no load
speed
n ......................rated
........................speed
.....................earthing
terminal
.....................safety alert
symbol
3
• Do not charge or use the battery pack in explosive
atmospheres, such as in the presence of flammable liquids,
gases or dust. Inserting or removing the battery pack from the
charger may ignite the dust or fumes.
• NEVER force the battery pack into the charger. DO NOT
modify the battery pack in any way to fit into a non-
compatible charger as battery pack may rupture causing
serious personal injury. Consult the chart at the end of this
manual for compatibility of batteries and chargers.
• Charge the battery packs only in designated D
• DO NOT splash or immerse in water or other liquids.
• Do not store or use the tool and battery pack in locations
where the temperature may reach or exceed 105 °F (40 °C)
(such as outside sheds or metal buildings in summer). For
best life store battery packs in a cool, dry location.
WARNING: Fire hazard. Never attempt to open the battery pack
for any reason. If the battery pack case is cracked or damaged, do
not insert into the charger. Do not crush, drop or damage the battery
pack. Do not use a battery pack or charger that has received a sharp
blow, been dropped, run over or damaged in any way (e.g., pierced
with a nail, hit with a hammer, stepped on). Damaged battery packs
should be returned to the service center for recycling.
WARNING: Fire hazard. Do not store or carry the battery
pack so that metal objects can contact exposed battery
terminals. For example, do not place the battery pack in aprons,
pockets, tool boxes, product kit boxes, drawers, etc., with loose
nails, screws, keys, etc. Transporting batteries can possibly
cause fires if the battery terminals inadvertently come in
contact with conductive materials such as keys, coins, hand
tools and the like. The US Department of Transportation Hazardous
Material Regulations (HMR) actually prohibit transporting batteries in
commerce or on airplanes (e.g., packed in suitcases and carry-on
luggage) UNLESS they are properly protected from short circuits. So
WALT chargers.
E