Whirlpool 920 Series Use And Care Manual page 19

NOTE:
A special adapter must be installed
on the faucet before the dishwasher can be
connected. Complete instructions and the
adapter are packed with your dishwasher.
When moving your dishwasher make sure
the door is latched. Hold the dishwasher at
the top front corners.
Connecting the dishwasher
1.
Run water at faucet until it is
hot.
Turn
water off.
2. Pull hoses out of their storage compart-
ment on the back of the dishwasher.
NOTE:
Make sure the hoses are not
kinked or twisted. Kinked hoses reduce
washing performance.
3. Pull down on the locking collar while
lifting the hose connector onto the faucet
adapter.
4. When the connector snaps into place,
release the locking collar.
5. Turn the hot water on slowly until it is all
the way on.
6. Plug in power supply cord.
7. See the "Start Up Guide" section for
instructions on how to start the dishwasher.
Locking collar
/
' Hose connector
Drawing water when dishwasher is
connected
You can draw water from the faucet while
l
Press the red button on the hose connec-
the dishwasher is connected.
Do
not
draw
tor to draw water from faucet. (The faucet
water while the dishwasher is filling or while
is set on hot. Adjust faucet for the water
water is being pumped out. (This helps
temperature you want.)
NOTE: Turn hot water back on after you
draw water from faucet. Turn off cold water.
prevent a lowfjll when dishwasher is'filling
or mixing drain water with fresh water.)
19