Page 2
IMPOR TANT NOTICE This manual has been provided for the use of authorized Yamaha Retailers and their service personnel. It has been assumed that basic service procedures inherent to the industry, and more specifically Yamaha Products, are already known and under- stood by the users, and have therefore not been restated.
SLG-100N 3 7 63 1515 0 SPECIFICATIONS Neck Mahogany Body Maple Fingerboard Rosewood Bridge Rosewood Frame Unit Maple Strings Nylon Guitar Strings Sensors B-BAND Connectors/Controls • AUX IN • AUX IN Level Control • LINE OUT jack (monaural) • PHONES jack (stereo) •...
Page 4
¥ CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME ¸ LA NORME NMB-003 DU CANADA. SILENT GUITAR MODEL SLG-100N AC POWER ADAPTOR : YAMAHA PA-1E OR PA-3B OR PA-D09 BATTERY : 9V 6LR61 OR 6F22Y BATTERY : 9V 6LR61 OR 6F22Y MADE IN TAIWAN AUX VOL...
Page 5
¥ CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME ¸ LA NORME NMB-003 DU CANADA. SILENT GUITAR MODEL SLG-100N AC POWER ADAPTOR : YAMAHA PA-1E OR PA-3B OR PA-D09 BATTERY : 9V 6LR61 OR 6F22Y BATTERY : 9V 6LR61 OR 6F22Y MADE IN TAIWAN PHONES ON/OFF switch...
Page 6
SLG-100N 3 7 63 1515 0 CIRCUIT BOARD LAYOUT Body (rear view) Panel Assembly (underneath the panel assembly) L 13942296513 Jack u163 http://www.xiaoyu163.com...
SLG-100N 3 7 63 1515 0 DISASSEMBLY PROCEDURE Preparations Make the following preparations; Turn off the power switch. Remove the battery cover and battery. Left Frame (Time required: About 2 minutes) 1-1 Loosen the adjusting bolt (front) marked [E15] and the adjusting bolt (rear) marked [E16].
Page 8
SLG-100N 3 7 63 1515 0 (Time required: About 5 minutes) 5-1 Remove the three (3) strings in left side (4 strings) and right side (1 strings) each. (Fig.2) 5-2 Remove the four (4) screws marked [E03] in left and right each.
Page 9
SLG-100N 3 7 63 1515 0 PUP Circuit Board (Time required: About 5 minutes) 8-1 Remove the panel assembly. (See procedure 6.) 8-2 Remove the four (4) screws marked [F02]. The panel holder assembly can then be removed. (Fig.1) 8-3 Remove the PUP circuit board from the two (2) spacers.
SLG-100N 3 7 63 1515 0 LSI PIN DESCRIPTION YSS234 (XN299A00) (Digital Sound Processor) MA: IC01 NAME FUNCTION NAME FUNCTION AVDD DC A+5Vs bus DC D+5V External RAM interface data TST0 DC D+5V ...
Page 11
SLG-100N 3 7 63 1515 0 CIRCUIT BOARDS MA Circuit Board Note: See parts list for details of circuit board component parts. L 13942296513 Component side Pattern side PUP Circuit Board AUX Circuit Board AUX IN AUX VOL MIN/MAX...
Page 12
SLG-100N 3 7 63 1515 0 INSPECTIONS 1. Required Equipment High-sensitivity AC voltmeter (level meter) Battery (006P) or power adapter (PA-D09) 2. Noise Level Measurement Load resistance [PHONES] jack: 39Ω (right and left each) [LINE OUT] jack: 10kΩ (1) Turn on the power to the main unit, turn on the [PHONES] switch, and check that the power LED (green) lights up.
Page 13
SLG-100N 3 7 63 1515 0 TUNING Use a tuning meter, pitch pipe, tuning fork, piano, etc., and to the open strings to the pitches shown below. • If the string’s pitch is high, loosen the string until the string’s pitch is slightly lower than the tuning pitch, then tune while raising the string’s pitch.
Page 14
http://www.xiaoyu163.com to Pickup (B-BAND) 3 7 6 3 1 5 1 5 0 Note: D7 is not installed. VOLUME SRAM 256K OP AMP PHONES OP AMP Note SYSTEM RESET SYSTEM RESET OP AMP LINE OUT TONE CONTROL AUX VOL OP AMP OP AMP TREBLE 0.012u...
3 7 63 1515 0 Guitar SLG-100N PARTS LIST CONTENTS OVERALL ASSEMBLY ..........2 PANEL ASSEMBLY ......... 4 L 13942296513 ELECTRICAL PARTS ..........6 Notes : DESTINATION ABBREVIATIONS A : Australian model M : South African model B : British model...