Maintenance - DeWalt DCL510 Instruction Manual

To install the battery pack (A) into the worklight, align the battery pack
with the rails inside the handle and slide it firmly into place until you
hear the lock snap into place.
To remove the battery pack
FIG. 3
from the worklight, press the
release button (B) and firmly
B
pull the battery pack out of
the handle. Insert it into the
charger as described in the
A
charger section of this
manual.
Switch (Fig. 2A)
To turn the light on, press the switch (C). To turn it off, press the switch
again.
Magnets, Belt Hook and Stand (Fig. 2)
CAUTION: When magnet and belt hook is in use, do not shake
light. Personal injury or property damage may occur.
CAUTION: When light is hung by the magnet and belt hook, do not
shake the light or object that it is hanging from. Do not hang the light
from any electrical wires or anything that it is not secure. Personal
injury or property damage may occur.
CAUTION: Only use the magnet and belt hook for hanging the
LED worklight. The magnet and belt hook are not intended to support
additional weight. Do not attach or hang anything additional to the
light or risk of breakage may occur.
CAUTION: Do not use the magnet and belt hook to reach with
or use the magnet and belt hook to support your weight in any
situation.
Using the stand (D), belt hook (F) and magnets (G), the worklight can
be placed in multiple locations for ideal lighting.
The kickstand should be snapped into the home position if not in use,
as shown in Figure 2A.
Pivoting Head (Fig. 4)
The pivoting head provides light in any direction by rotating 180˚ in
both directions.
FIG. 4

MAINTENANCE

WARNING: To reduce the risk of serious personal injury,
turn tool off and disconnect battery pack before making any
adjustments or removing/installing attachments or accessories.
9