Localisation After Factory-Reset; Reset (Flashmenu) - Sharp SL-C1000 Quick Start Manual

SL-C1000/3000/3100 Quickstart

Localisation after factory-reset

With a special reset procedure it is possible to bring the Zaurus back to factory state. If
you played too much with sensitive configuration files this is your best chance to get a
working Zaurus back.
Factory state means that the device will talk only japanese with you. With a backup on a
memory card the last working state is restored easily.
The data would be lost, if there were no backup. A "Localisation-Backup" can be
downloaded from our website http://www.trisoft.de and copied onto a memory card.
A recent backup must simply be read back via "Restore". The difficulty lies in the
recognition of the correct icons to click, but don't worry : Here comes the easy
step-by-step guide with pictures for your short journey through the japanese world of
Zaurus.
Attention :
The backup needs to be placed in a subdirectory called "Backup_Files" !
The Zaurus checks only this directory for backup sets.

Reset (Flashmenu)

To access the flash menu, the following steps are necessary:
•
Turn off the Zaurus, pull out the USB cable or other power supplies.
•
Unlock the battery compartment and take out the battery.
•
Wait for approx. 5 seconds.
•
Reinsert the battery, close the cover and turn the switch back to "Betrieb".
•
Connect the power supply and wait until the yellow charging LED lights up
(without AC connected, the Zaurus won't start the Reset procedure !).
SHARP SL-C1000/3000/3100
///TRIsoft OHG
Page 21