IWILL XP333 User Manual page 42

Chapter 4 BIOS Setup
KB Power-On Password
If you wish to use this function, highlight the field then press
<Enter>. The computer will display the message "Enter Pass-
word". Type in a password is displayed and re-type it at the
prompt. The KB Power-On function will be in effect after you
Save and Exit Setup.
To disable a password, highlight the field again and press <En-
ter>. The computer will display the message "Enter Password".
Press <Enter>. A message will confirm that the password is
disabled.
Hot Key Power-On
This field specifies key selection for the Keyboard-Power-On hot
key.
[Ctrl-F1 through Ctrl-F12]
Onboard FDC Controller
This field enables or disables the onboard floppy controller.
[Enabled(Default Value),Disabled]
Onboard Serial Ports
These fields configure the onboard serial ports. There are several
port addresses and IRQ channels to select from. The defaults are
the standard assignments for these ports.
42