CDP-CE105 3 7 63 1515 0 SERVICE MANUAL US Model Canadian Model AEP Model UK Model E Model Australian Model Model Name Using Similar Mechanism HCD-D670AV/N555AV CD Mechanism type CDM37-5BD19 Base Unit Type BU-5BD19 Optical Pick-up type KSS-213BA/F-NP L 13942296513...
PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE REPLACE THESE COMPONENTS WITH SONY PARTS FONCTIONNEMENT. NE REMPLACER CES COMPOSANTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY. DONNÉS DANS...
Page 3
http://www.xiaoyu163.com 3 7 63 1515 0 MODEL IDENTIFICATION SAFETY CHECK-OUT — BACK PANEL — After correcting the original service problem, perform the follow- ing safety checks before releasing the set to the customer: Check the antenna terminals, metal trim, “metallized” knobs, screws, 1 2 3 1 2 3 4-982-187-...
http://www.xiaoyu163.com SECTION 1 3 7 63 1515 0 SERVICING NOTE How to take out a compact disc when the power is turn OFF. Compact disc Rotate the table motor into the direction of arrow, lef the spindle motor down and take out the compact disc.
http://www.xiaoyu163.com 3 7 63 1515 0 3-3. BU BRACKET ASSEMBLY 2 BU bracket assembly 1 Yoke bracket L 13942296513 3-4. DISC TABLE Note: When the Disc table is installed, adjust the positions of Roller cam and mark ( as shown in the figure, then 1 Screw (BVTP 3x8) set to the groove of disc table.
http://www.xiaoyu163.com SECTION 4 3 7 63 1515 0 TEST MODE 4-1. AF MODE 4-2. ADJ MODE The following checks can be performed in the AF mode, which is The following operations are performed in the ADJ mode, which set by connecting the test point (AFJ) terminal on DISPLAY is set by connecting the test point (ADJ) terminal to the Ground and board to the Ground and turning on the power.
http://www.xiaoyu163.com SECTION 5 3 7 63 1515 0 ELECTRICAL BLOCK ADJUSTMENTS Note : S Curve Check 1. CD Block is basically designed to operate without adjustment. Note : Use the widely use remote commander with 20 keys for this Therefore, check each item in order given. check.
Page 10
http://www.xiaoyu163.com 3 7 63 1515 0 E-F Balance Check Adjustment Location Note : Use the widely use remote commander with 20 keys for this [BD BOARD] (Conductor Side) check. oscilloscope BD board RV101 TP(TEO) TP(VC) IC102 IC101 Procedure : RV103 1.
http://www.xiaoyu163.com 3 7 63 1515 0 6-6. IC PIN FUNCTION • IC401 SYSTEM CONTROL, FLUORESCENT INDICATOR TUBE DRIVE (CXP82316-065Q) Pin No. Pin Name Function — – Connected to Ground. RM IN Remote control signal input. — – Connected to Ground. Serial data latch signal output.
http://www.xiaoyu163.com SECTION 7 3 7 63 1515 0 EXPLODED VIEWS NOTE: • Abbreviation • Items marked “*” are not stocked since they are CND : Canadian model The components identified by mark ! seldom required for routine service. Some delay : German model or dotted line with mark ! are critical should be anticipated when ordering these items.
http://www.xiaoyu163.com 3 7 63 1515 0 7-4. BASE UNIT SECTION (BU-5BD19) M101 (including r A) L 13942296513 M102 S101 The components identified by mark ! or dotted line with mark ! are critical for safety. Replace only with part number speci- fied.
http://www.xiaoyu163.com SECTION 8 3 7 63 1515 0 ELECTRICAL PARTS LIST Note: • Due to standardization, replacements in the parts list • SEMICONDUCTORS The components identified by mark ! may be different from the parts specified in the In each case, u: µ , for example: or dotted line with mark ! are critical diagrams or the components used on the set.
Page 22
http://www.xiaoyu163.com CD MOTOR DISPLAY 3 7 63 1515 0 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark < VIBRATOR > R114 1-216-101-00 METAL CHIP 150K 1/10W R115 1-216-101-00 METAL CHIP 150K 1/10W X101 1-579-280-11 VIBRATOR, CRYSTAL (16.9344MHz) R116 1-216-061-00 METAL CHIP 3.3K...
Page 23
http://www.xiaoyu163.com DISPLAY DOOR SW FUNCTION MAIN 3 7 63 1515 0 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark < FLUORESCENT INDICATOR > S521 1-762-196-21 SWITCH, TACT (p) S522 1-762-196-21 SWITCH, TACT () ±) FL401 1-517-522-11 INDICATOR TUBE, FLUORESCENT S523 1-762-196-21 SWITCH, TACT (≠...
Need help?
Do you have a question about the CDP-CE105 and is the answer not in the manual?
Questions and answers