Replacing The Oven Light Bulb; Changing Halogen Bulbs - NEFF B46C74.3 Instruction Manual

Problem
‹‹‹ flashes in the temperature display
Smoke is generated during roasting or
grilling
High levels of condensation are generated
in the cooking compartment
Enamelled accessories have matt, light-
coloured marks
Door panels are misted up
Cooked dishes turn out too moist or too
dry when cooking with steam-assisted
applications
The appliance requires frequent descaling The water hardness has been set too high Check the water hardness in the Basic set-
"E870" appears in the temperature display The pump has pumped air several times in
"E8XX" appears in the temperature display The steam-assisted function is malfunc-

Replacing the oven light bulb

Replace faulty oven light bulbs.
You can obtain replacement light bulbs from customer service
or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to
300 °C. Only use these oven light bulbs.
:
Risk of electric shock !
Disconnect the appliance from the power supply. Switch off the
circuit breaker or remove the fuse from the household fuse box.
Place a tea towel in the cold cooking compartment to prevent
1.
damage.
Turn the glass cover anticlockwise and remove it.
2.
Replace the oven light bulb with a bulb of the same type.
3.
Screw on the glass cover again.
4.
Remove the tea towel and switch on the circuit breaker.
5.
Note: If the glass cover cannot be unscrewed: use rubber
gloves to turn it. You can order a special removal tool through
the after-sales service (order no. 613634)

Changing halogen bulbs

Spare bulbs can be obtained from the after-sales service or
specialist retailers. Verwenden Sie nur diese Halogenlampen:
Osram HALOSTAR ECO, 12 V, GY 6.35, 25 W
:
Risk of burns!
Halogen bulbs become very hot when switched on. When
replacing them, wait until the bulb has cooled down.
Possible cause
Appliance is not switched off.
Fat is burning on the grill element
Wire rack or universal pan inserted incor-
rectly
Normal occurrence (e.g. when baking
cakes with very moist toppings or roasting
a large joint)
Normal occurrence caused by dripping
meat or fruit juices
Normal occurrence caused by tempera-
ture differences
The wrong altitude range has been set
The wrong steam intensity was selected
succession
tioning
Caution!
Clouding in halogen bulbs: Do not touch halogen bulbs with
bare fingers. This causes oils to get onto the glass which are
then burnt on and cloud the glass. Use a clean cloth to change
the bulb.
Remove the appliance door (see section: Removing and
1.
refitting the appliance door).
Remove the door panel (see section: Cleaning the door
2.
panels).
Unclip the defective halogen bulb and the bulb fitting from the
3.
holder, and carefully remove it from the reflector.
Remove the defective halogen bulb from the bulb fitting
4.
(fig. A).
Insert a new halogen bulb into the bulb fitting. Use a clean
5.
cloth to do this (fig. B).
Reinsert the bulb fitting into the appliance door.
6.
Fit the door panel and appliance door.
7.
Remedial action
Turn the operating mode selector back to
the Û position and lock it in place
Continue grilling or roasting until the fat on
the grill element has burnt away
Check the shelf heights (see section:
Roasting or grilling)
Open the appliance door briefly from time
to time during operation
Not possible
Heat the appliance up to 100 °C and then
switch off again after 5 minutes
Check the altitude range in the Basic set-
tings menu and adjust if necessary
Select a higher or lower steam intensity
tings menu and adjust if necessary
Press the clock function button.
KJ
Fill the water tank and slide it fully in
Press the clock function button.
KJ
Note: Applications without steam assis-
tance are ready for operation
41