Benelli 2009 TREK1130 Workshop Manual page 209

CHAS
4 47
4 Fill:
• the brakes liquid tub
(with the specified quality of recommended brakes
liquid)
TOP
4
WARNING
• Use only the prescribed brakes liquid. The use of
other types of brakes liquid may damage the
rubber gaskets, causing leaks and deteriorating
the performances of the brakes.
• Top-up using the same type of brakes liquid
already present inside the system. The brakes
liquid must never be mixed with liquids of other
brands, in that it may cause a dangerous
chemical reaction, with the consequent
deterioration of the performances of the brakes.
• During top-up, be careful not to let water flow
inside the tub. The presence of water will
significantly reduce the boiling point of the
brakes liquid and may cause vapour to form.
ATTENTION
• The brakes liquid can damage the painted
surfaces and the plastic parts. Therefore, always
immediately clean all brakes liquid spills.
5 Bleed:
• the braking plant
See "ROUTINE INSPECTIONS AND ADJUSTMENTS
3.58" paragraph.
6 Check:
• the brakes liquid level
If below the minimum level notch
to the correct level using the recommended brake
liquid.
See "ROUTINE INSPECTIONS AND ADJUSTMENTS
3.55" paragraph.
6
7 Check:
• the functioning of the brake lever
If the brake lever is soft or spongy to touch
Bleed the braking plant.
See "ROUTINE INSPECTIONS AND ADJUSTMENTS
3.58" paragraph.
FRONT AND REAR BRAKES
Recommended brakes liquid
TUTELA BRAKE FLUID
TOP 4 - DOT 4
. .
Top-up