Kenmore 106 series Use And Care Manual page 18

To start ice maker, lower the wire shut-off arm to the ON
position (arm down). Do not force the arm up or down. Do
not store anything on top of the ice maker or in the ice
storage bin.
It is normal for the ice cubes to be attached at the
corners. They will break apart easily.
The ice maker will not operate until the freezer is cold
enough to make ice. This can take as long as
overnight.
If ice is not being made fast enough and more ice is
needed, turn the Freezer Control toward a higher
(colder) number in half number steps. (For example, if
the control is at 3, move it to between 3 and 4.) Wait 24
hours and, if necessary, gradually turn the Freezer
Control to the highest setting, waiting 24 hours
between each increase.
REMEMBER:
The quality of your ice will be only as good as the
quality of the water supplied to your ice maker.
Avoid connecting the ice maker to a softened water
supply. Water softener chemicals (such as salt) can
damage parts of the ice maker and lead to poor quality
ice. If a softened water supply cannot be avoided,
make sure the water softener is operating properly and
is well maintained.
To remove the shelf:
1. Lift entire shelf slightly.
2. Move shelf all the way to one side.
3. Tilt other side up and out of shelf supports.
4. Pull shelf up and out.
3&4
1
To replace the shelf:
1, Tilt the shelf and insert into freezer compartment.
2, Insert one end of the shelf all the way into the center of
the shelf supports.
3, Lower other end of shelf and insert into the shelf
supports.
4, Lower shelf into place.
4
NOTE: The shelf should lower slightly and lock into place.
If the shelf does not appear stable, make sure both ends of
the shelf are inserted into the shelf supports.
The freezer
back of the
To
1,
2,
3,
=
5.
D ,,=i "= t ,,,'v"
t ull-ou[ F eze[
floor pulls out for easier access to foods in the
freezer and for easier cleaning.
remove the freezer floor:
Remove all food items from the freezer floor.
Lift both back "fences" up and out (on some models).
Pull the floor out about 1 inch (2.5 cm) with one hand
around the air tower section (center back) and one
hand at center front.
Lift up floor at rear until hooks release from cabinet.
Pull floor out the rest of the way.
To
1,
2.
=
replace the freezer floor:
Position back of floor into freezer opening.
Slide floor straight in until hooks drop into place at rear
of cabinet.
Replace "fences" by aligning pins with socket in the
floor, and pushing down until they snap into place (on
some models).
18