Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Livestrong LS8.0T
Summary of Contents for Livestrong LS8.0T
- Page 1 LS8.0T Service Manual...
-
Page 2: Table Of Contents
TABLE OF CONTENTS CHAPTER 1: SERIAL NUMBER LOCATION……………………………………………..………….3 CHAPTER 2: PREVENTATIVE MAINTENANCE 2.1 Preventative Maintenance……………………………………………………………….…………………4 2.2 Tension and Centering the Running Belt…………………………………………………….…………...6 CHAPTER 3: ENGINEERING MODE 3.1 Engineering Mode…………………………………….………………………………………….….……..7 3.2 Engineering Mode Overview…………………………………………….…………………………..…….8... -
Page 3: Chapter 1: Serial Number Location
CHAPTER 1: Serial Number Location 1-1 Serial Number Location... -
Page 4: Chapter 2: Preventative Maintenance
CHAPTER 2: Preventative Maintenance 2.1 PREVENTATIVE MAINTENANCE Preventative maintenance is the key to smoothly operating equipment, as well as keeping the user’s liability to a minimum. Equipment needs to be inspected at regular intervals. Defective components must be replaced immediately. Improperly working equipment must be kept out of use until it is repaired. -
Page 5: Preventative Maintenance
CHAPTER 2: Preventative Maintenance 2.1 PREVENTATIVE MAINTENANCE EVERY 6 MONTHS OR 150 MILES It is necessary to lubricate your treadmill running deck every six months or 150 miles (240 kilometers) to maintain optimal performance. Once the treadmill reaches 150 miles (240 kilometers), the console will display the message “LUBE”... -
Page 6: Tensioning & Centering The Running Belt
CHAPTER 2: Preventative Maintenance 2.2 TENSIONING & CENTERING THE RUNNING BELT If you can feel a slipping sensation when running on the treadmill, the running belt must be tightened. In most cases, the belt has stretched from use, causing the belt to slip. This is a normal and common adjustment. To eliminate this slipping, turn the treadmill off and tension both the rear roller bolts using the supplied Allen wrench, turning them ¼... -
Page 7: Chapter 3: Engineering Mode
CHAPTER 3: Engineering Mode 3.1 ENGINEERING MODE “－ － － － ” “▲” 1) To enter Engineering Mode, press & hold the INCLINE UP and SPEED DOWN keys at the same time for 3-5 seconds until Engineering Menu appears on the display. 2) Use the INCLINE and SPEED UP and DOWN keys to select a parameter. -
Page 8: Engineering Mode Overview
CHAPTER 3: Engineering Mode 3.2 ENGINEERING MODE OVERVIEW MODE FUNCTION DESCRIPTION ENG 0 Display Test Start Key – LCD/LED on Stop Key – LCD/LED off Any Other Key - Will show on the display window. Hold the STOP key for 3 seconds to return to the Engineering Menu. ENG 1 Hardware Test Motor &...
Need help?
Do you have a question about the LS8.0T and is the answer not in the manual?
Questions and answers