Table of Contents
Advertisement
Carbon Monoxide
Battery operated CO alarm
without Digital display
MODEL: KN-COB-B
ASSEMBLY: 9CO5
For questions concerning your Carbon Monoxide Alarm,
please call our Consumer Hotline at 1-800-654-9677.
Please have the following information ready when calling:
CO Alarm Model Number
CO Alarm Assembly Number
Date of Manufacture
Date of Purchase:
Where Purchased:
ATTENTION Please take a few minutes to thoroughly read this manual which
should be saved for future reference and passed on to any subsequent owner.
Battery Operated
Alarm
User's Guide
(Located on the back of alarm):
(Located on back of alarm):
(Located on back of alarm):
Battery operated CO alarm
With Digital Display and
Peak Level memory
MODEL: KN-COPP-B
ASSEMBLY: 900-0146
810-2132
REV B
Advertisement
Table of Contents
Related Manuals for Kidde KN-COB-B
Summary of Contents for Kidde KN-COB-B
- Page 1 Battery operated CO alarm Battery operated CO alarm without Digital display With Digital Display and Peak Level memory MODEL: KN-COB-B MODEL: KN-COPP-B ASSEMBLY: 9CO5 ASSEMBLY: 900-0146 For questions concerning your Carbon Monoxide Alarm, please call our Consumer Hotline at 1-800-654-9677.
-
Page 2: Table Of Contents
......Your new Kidde CO alarm has a five year limited warranty. Please Troubleshooting Guide . -
Page 3: Kidde Product View
Kidde Product View Kidde Product View non-digital 9CO5 model 900-0146 Digital display model TEST TEST PEAK MOVE TO RESET RESET LEVEL FRESH AIR Operate Alarm Operate Alarm CARBON MONOXIDE ALARM CARBON MONOXIDE ALARM... -
Page 4: Quick Set Up
After approximately 30 seconds, your or furnace room. CO alarm will begin monitoring for CO. Recommended Locations Your Kidde CO Alarm is now operational. Upper Levels of Home DINING KITCHEN BEDROOM BEDROOM LIVING ROOM... -
Page 5: Mounting
Figure 1 3. Hook the Kidde CO Alarm unit over the screws onto keyholes in back Dust, grease and household chemicals can affect the sensor. of unit. •... -
Page 6: Digital Display
The display should change to the Digital Display - Shows CO level in PPM normal display (see figure 3) approximately Your Kidde CO alarm continuously displays a digital readout of 30 seconds after pressing the test/reset button. Figure 4 the CO level in Parts Per Million (PPM). - Page 7 30 PPM or a CO alarming device immediately. that is in alarm. Refer to page 18 for more details. Note: Your Kidde CO Alarm will NOT monitor CO levels while an error warning is being displayed. Low Battery If the batteries become “low”, the alarm will...
-
Page 8: Test Reset Button/Lights
Figure 9 Due to the loudness of the alarm we suggest you place your fingers is pressed. over the sounder opening when testing your Kidde CO Alarm. Reset If the alarm is sounding, pressing the test/reset button will terminate the alarm. If the CO condition that caused the alert in the first place continues, the alarm will reactivate. - Page 9 Installation/Replacement Battery Replacement/Installation Instructions Since batteries are not installed in the unit at the factory, you will To install or replace the batteries in your Kidde unit please per- need to install them. form the following steps: Three AA batteries have been included with your purchase. When 1.
- Page 10 Part Four – What to do When the What To Do If The Alarm Sounds (cont.) Alarm Sounds Symptoms of CO Poisoning The following common symptoms are related to carbon monoxide WARNING: Actuation of your CO poisoning and should be discussed with ALL members of the Alarm indicates the presence of Carbon household.
- Page 11 To keep your CO alarm in good working order, please sures to low levels may cause symptoms, as well as short-term follow these simple steps: exposures to high levels. This Kidde unit has a time-weighted alarm - the higher the level of carbon monoxide present, the sooner •...
-
Page 12: Battery Installation/Replacement
Troubleshooting Guide Caring for your Kidde Battery Powered CO Alarm (cont.) Symptom Problem Action Move the CO alarm and place in another location prior to per- 1 chirp every 30 sec- forming any of the following: See pages 16-17. onds with a red LED Batteries are low •... -
Page 13: Frequently Asked Questions
Wall Mounting Template Frequently Asked Questions If you are going to mount your Kidde CO Alarm to the wall, you may use this template for exact placement of the two wall mount How many CO alarms do I need? screws provided. For more information about mounting to the wall, please refer to page 8. -
Page 14: Product Specifications
: Electrochemical carbon monoxide sensor SENSOR MATERIAL AND WORKMANSHIP FOR A PERIOD OF FIVE (5) YEARS FROM DATE : Each Kidde CO Alarm is calibrated to a CO con- ACCURACY OF PURCHASE. THE MANUFACTURER’S LIABILITY HEREUNDER IS LIMITED TO REPLACEMENT OF THE PRODUCT, REPAIR OF THE PRODUCT OR REPLACE- centration of 150 ppm (+/-25 ppm) in air, at 80°F... -
Page 15: Notes
Important: Do not remove back cover. Back cover removal will void warranty. Your Kidde Carbon Monoxide Alarm is not a substitute for property, dis- ability, life or other insurance of any kind. Appropriate insurance cov- erage is your responsibility. Consult your insurance agent.
Need help?
Do you have a question about the KN-COB-B and is the answer not in the manual?
Questions and answers