Tunebug Shake Quick Set Manual

Tunebug Shake Quick Set Manual
Turn On/Off Power
1.
!Fully Charge Before Operating!
POWER ON
Place fingers over
Touch Sensitive Areas
indicated for 2 seconds.
Shake will flash Green then go
POWER OFF
Place fingers over
Touch Sensitive Areas
indicated for 5 seconds,
Shake will flash Red then turn off.
Charging
Turn off Power before charging.
2.
Connect & Play
Set Shake to Pair
1. From Off, place fingers over
designated controls for 4 sec.
until Shake flashes
Connect to Bluetooth
1. Go to your audio device settttings
and enable the Bluetooth function.
2. Once your audio device identifies
the "TUNEBUG SHAKE",
accept the connection.
Blue.
3. Some devices require a security
code. Type "0000".
Your Now Connected
& Ready To Play
Tunebug 830 Stewart Dr. #201 Sunnyvale Ca. 94085 www.tunebug.com 408.792.7022
Connect with
3.
Red / Blue .
VOLUME UP
Press and hold finger
over right Control Area
to increase Volume.
Shake will flash
Green
increase.

Adjust Volume

at each
VOLUME DOWN
Press and hold finger
over left Control Area
to decrease Volume.
Shake will flash Green
at each decrease.
www.tunebug.com
408.792.7022