Assembly And Adjustments - DeWalt D28106-XE Instruction Manual

FIG. 1
C
D28402-XE
F
I
D28106-XE
D28113-XE
D28130-XE
D28135-XE
D28139-XE
S
A
K
B J
L
K
G
H
K

ASSEMBLY AND ADJUSTMENTS

Attaching Side Handle
The side handle (E) can be fitted to either side of the gear
case in the threaded holes, as shown. Before using the
tool, check that the handle is tightened securely.
Rotating the Gear Case
WARNING: Turn off and unplug the tool before making
any adjustments or removing or installing attachments or
accessories. Before reconnecting the tool, depress and
release the paddle switch to ensure that the tool is off.
1. Remove guard and flanges from tool.
2. Remove the four corner screws attaching the
gear case to motor housing.
3. Separating the gear case from motor housing
not more than 6 mm (1/4"), rotate the gear
case head to desired position.
NOTE: If the gear case and motor housing
become separated by more than 6 mm (1/4"),
the tool must be serviced and re-assembled by
a D WALT service center. Failure to have the tool
E
serviced may cause brush, motor and bearing failure.
3. Re-install screws to attach the gear case to the motor housing. Tighten screws to
2 nm (18 in.lbs.) torque. Overtightening could cause screws to strip.
Accessories
It is important to choose the correct guards, backing pads and flanges to use
with grinder accessories. See pages 7–8 for information on choosing the correct
accessories.
WARNING: Accessories must be rated for at least the speed recommended on the
tool warning label. Wheels and other accessories running over rated accessory speed
may burst and cause injury. Threaded accessories must have a M14x2 hub. Every
unthreaded accessory must have a 22 mm (7/8") arbor hole. If it does not, it may
5
E
90˚ 90˚