Connections; Connecting To Cctv Camera, Monitor, And Sensor - Mitsubishi Electric DX-NT400E Installation And Operation Manual

Connections

Connecting to CCTV camera, monitor, and sensor

To AUDIO OUT connector
~
AC IN
POWER CORD
for the Continent
for U.K
ALARM IN Input terminal
• Input Circuit
10k
22k
Input
terminal
GND
<Interface circuit inside the unit>
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
12
To VIDEO OUT
ON
MAIN
VIDEO
OFF
OUT
OUT AUDIO
GND
To GND
terminal
MODE OUT 1 to 5 Output terminal
• Output Circuit
5V
0.047 F
5V
<Interface circuit inside the unit>
To AUDIO IN connector
To VIDEO IN connector
connector
CAMERA #1
To CAMERA IN 1 connector
Up to 4 cameras
1 2 3 4
CAMERA IN
RESET
IN
To ALARM IN terminal
corresponds to the
CAMERA #.
SENSOR #1
Output terminal
GND terminal
MONITOR
CAUTION
Connecting a coaxial transmission
camera incorrectly may damage the
input terminal. Be careful.
RS-232C ETHERNET
Processing the connecting line
Connection on the ALARM IN
terminals and the I/O terminals
Compatible power lines
ø0.32 - ø0.65 mm (AWG 28 - 22)
Cut the designated area from the
electric wire's outer covering
(vinyl portion).
5 - 7 mm