Table of Contents
Advertisement
Problem
The cycle is longer than
the time displayed.
The washing results are
not satisfactory.
You cannot set an op-
tion.
The appliance does not
dry or does not dry cor-
rectly.
The laundry is full of dif-
ferent colours fluff.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
16. EMERGENCY DOOR OPENING
In case of power failure or appliance failure
the appliance door remains locked. The
washing programme continues, when the
power is restored. If the door remains
locked in case of failure, it is possible to
open it using the emergency unlock
feature.
Before opening the door:
Possible solution
An unbalanced laundry load increases the duration time. This
is a normal behaviour of the appliance.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before
you wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Make sure that you press only the wanted button(s).
Turn the water tap on.
Make sure the drain filter is not clogged.
Reduce the laundry load.
Make sure you have set the correct cycle. if necessary ,set
again a short drying time.
The fabrics washed in the previous cycle released fluff of a
different colour:
• The drying phase helps to eliminate some fluff.
• Clean the clothes with a fluff remover.
In case of an excessive amount of fluff in the drum run the
special programme to clean it (refer to "Fluff in the fabrics" for
more details).
CAUTION!
Make sure that the water
temperature and the
laundry are not hot. Wait
till they cool down, if
necessary.
ENGLISH
29
Advertisement
Table of Contents
