Programming Proximity Tags - Texecom Premier 412 User Manual

Premier 412/816/832 User Guide
Light Fault Condition
General Warnings
Press (Key 1) to view the warning,
lights 1-5
following:-
1
1 = AC Fail
2 = Arming Fob has Low Battery
3 = Soak Test Active
Telephone Line Fault
2
2-Wire Smoke Alarm
3
Box Tamper & Auxiliary Input:
Press to view type, lights 1 - 6
indicate:
1 = Box Tamper
Auxiliary Tamper *
4
2 = Auxiliary Tamper
Tamper * (UK Bell Module)
3 = Auxiliary PA
Radio Plus Tamper
7 = Low Fob Battery
Code Tamper

Programming Proximity TAGS

PREMIER 412, 816 & 832
To assign a Proximity TAG to a User, proceed as
follows:
1. Program a User code or use an existing User code
2. Press and
TAG No.>------' will now appear
3. Enter the CODE of the User that you want to
assign a TAG to
press
4. Present the Proximity TAG to the keypad within 10
seconds
5. A confirmation tone will be heard, the TAG is now
programmed.
3
Service Faults Displayed on LED Keypads
will indicate the
4 =
5 = Bell
6 =
8 = User
together, 'TAG Programming.
Light
Date or Time Lost
5
Zone Tamper/Trouble
6
Press
Keypad Tamper/Removed
7
Press
Equipment Faults
Press
Light 1 = Output 1 Fault
Light 2 = Output 2 Fault
Light 3 = Siren/Bell Fault
Light 4 = 2-Wire Smoke Sensor Fault
8
Light 5 = Auxiliary Fuse Failed
Light 6 = Battery Fault
Light 7 = Service Timer/Zone Soak Test Failed
Light 8 = Communication Fault
Arming
PREMIER 412, 816 & 832
To Arm the Control Panel, proceed as follows:
1. Present the Proximity TAG to the keypad (the
display will show 'Do You Want To Arm System?)
2. Press
Note:- If Quickarm is enabled the system will start
the exit time immediately.
and
Disarming
To Disarm the Control Panel, proceed as follows:
1. Enter the building Via the designated Entry point
(the entry tone will sound)
Present the TAG to the keypad, the entry tone will stop,
the alarm is now disarmed
Fault Condition
to view zone number
to view keypad number
to view fault type:
and the exit will start, leave the building
INS195-4