Water Pump; Removal And Disassembly - Suzuki VL800 Service Manual

Hide thumbs Also See for VL800:

Table of Contents

6-10 COOLING SYSTEM

• Keep on heating the water to raise its temperature.

• Just when the water temperature reaches specified value, the

thermostat valve should have lifted by at least 6.0 mm (0.24 in).

$ Thermostat valve lift

Standard: Over 6.0 mm at 90°C (Over 0.24 in at 194°F)

• A thermostat failing to satisfy either of the two requirements

(start-to-open temperature and valve lift) must be replaced.

INSTALLATION

Install the thermostat in the reverse order of removal.

WATER PUMP

• Drain engine coolant. (#2-13)

• Remove the secondary gear case cover.

• Remove the reserve tank 1 and the water hose 2.

• Remove the water pump case.

• Remove the water pump.

Table of Contents

Do you have a question about the VL800 and is the answer not in the manual?

April 10, 2025

If I don't have a carburetor search control valve on mine where does the hose come from carburetor go to

Mr. Anderson

April 10, 2025

On a Suzuki VL800, the hose from the carburetor connects to the intake pipe if there is no carburetor surge control valve.

This answer is automatically generated

Intruder vl800