Millett TRS-1 Installation And Use Manual

Tactical rifle scope

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

Download this manual

I N S T R U C T I O N a n d O P E R AT I O N

TRS-1

TRS-2

T T A A C C T T I I C C A A L L R R I I F F L L E E S S C C O O P P E E

Installation and use of Millett Tactical TRS-1 and TRS-2 scopes

TRS-1

TRS-2

Before starting make sure firearm is UNLOADED!!

Table of Contents

Need help?

Do you have a question about the TRS-1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Millett TRS-1

Page 1 T T A A C C T T I I C C A A L L R R I I F F L L E E S S C C O O P P E E Installation and use of Millett Tactical TRS-1 and TRS-2 scopes...
Page 2 TRS-1 scope mounted on a tactical rifle using Millett Angle-Loc™ rings and Picatinny rail. Mounting Mounting your scope properly is important to the accuracy and durability of your firearm and scope. Proper mounting assures that the scope is aligned to the barrel and the scope is rigged to the rifle for accuracy.
Page 3 Boresighting Boresighting is aligning the scope to the bore of the rifle to assist you in getting on target when sighting in the rifle. There are several ways to boresight a rifle, 1. Looking through the scope and the bore of the rifle until they are both at the same point.
Page 4 Using the features of the TRS scopes The TRS was designed to give the shooter the most useful features needed under the most demanding use and conditions. To get the full benefit of the features it’s best to learn their use before needing them. Try the different TRS features before you need them under varying conditions.
Page 5 Zoom ring On the TRS-1 you have a Zoom Ring that allows you to adjust the magnification of the scope for differing shooting conditions. The scope is variable from 4X to 16X power. The Mil-Dotbar is set to be 1 mil at 10X on the Zoom Ring. At this position, the Mil-Dot and Mil-Dotbar is 3.6 inches at 100 yards.
Page 6 100 yards. The TRS-1, and TRS-2 scopes Mil- Dotbar is set for use at 10 X. On the TRS-1 if you are not on 10 X power you will have to adjust your measurement using the Mil-Dotbar chart below.
Page 7 CHART 2 Power: Objective lens: Field-of-view ft at 100 yards: High Exit pupil diameter: High power Low power Battery: Eye relief: Body Construction: One piece heat treated aluminum 30mm tube CHART 3 Power: Objective lens: Field-of-view ft at 100 yards: Exit pupil diameter: Battery: Eye relief:...
Page 8 Care of your scope Your Millett TRS scope is designed to give many years of service in the most demanding of conditions, but it does require proper care and treatment. Your scope is waterproof, and will not be harmed by rain, snow and dampness, but the electronics for the illumination, if submerged for any length of time in water may be damaged.

This manual is also suitable for:

Trs-2