AUTOHELM ST4000+ Owner's Handbook Manual page 83

Chapter 5: Installing the ST4000+
Installing the socket
1. Apply the template (supplied at the rear of this handbook) to the
2. Carefully drill a 18 mm (
3. Pass the cable through the bulkhead and attach to the socket,
4. Attach the socket to the bulkhead using the two self-tapping
Brown
bulkhead.
3
( / in) pilot holes. Remove the template.
32
making sure you connect each core to the correct pin (as shown).
Rear of socket
Drive (blue)
3 stripe terminal
To the
control unit
screws. Use cable clamps to secure the drive cable at regular
intervals.
23
/ in) clearance hole and two 2.5 mm
32
69
Blue
D3284-2
Terminal
identification
stripes
Drive (brown)
2 stripe terminal
D383-5