Summary of Contents for Alarm Controls Corporation SREX-100
- Page 1 ACTIVE INFRARED REQUEST TO EXIT SENSOR MODEL SREX-100 OPERATING INSTRUCTIONS ALARM DEER PARK, NY 11729 CONTROLS WWW.ALARMCONTROLS.COM...
- Page 2 It is U.L. listed as a request to exit device under the U.L. UL294 and the CAN/ULC-S319 standard. The SREX-100 is rated a “class 1” as per the CAN/ ULC-S319 standard. The SREX-100 is designed to mount over the door header so that its de- tection pattern is placed directly over the door handle.
-
Page 3: Led Indicators
STEP 4. Snap the PCB into the housing. The top of the PCB goes into the TROUBLE SHOOTING THE INSTALLATION If the SREX-100 is detecting erratically the sensor beams are reflecting off the handle. Adjust the angle of the sensor so the IR beams are in front of the handle. - Page 4 The Card Reader/Keypad and the Door Position Switch are dry inputs. ADJUSTMENT OF SENSOR FIELD The SREX-100 is factory pre-set at the five degree angle. If there is an obstruction in the sensor field preventing a clear view of the door handle it will be necessary to change the viewing angle.
-
Page 5: Adjustment Of Sensor
ADJUSTMENT OF SENSOR After the SREX-100 has been wired and powered the sensor can now be adjusted to the installation requirements. DETECTION RANGE The detection distance is adjusted by the RNG, (range), potentiometer located at the upper left hand side of the PCB. The range is 20 to 48 inches. - Page 6 STEP 3. Slide the PCB with clips attached from the housing. Do not remove clips. STEP 4. Position the SREX-100 drill template on door frame or above door frame over door handle. STEP 5. A 5/16” diameter hole is required in door frame or mounting surface to allow cable entry.
-
Page 7: Typical Installation Wiring
MODEL TS-2 MODEL U.L. FILE KP-100 NUMBER SA32686 NOTE: THE THREE INPUTS TO THE SREX-100 MUST BE USED AS A DRY INPUT WITH NO VOLTAGE APPLIED FROM THE CARD READER, DOOR POSITION SWITCH OR THE REQUEST TO EXIT STATION. PAGE 6... - Page 8 YOUR SOURCE FOR QUALITY SECURITY EQUIPMENT MAGNETIC LOCKS POWER SUPPLIES REQUEST TO EXIT STATIONS DIGITAL KEYPADS PUSHBUTTON CONTROL STATIONS PNEUMATIC TIME DELAY STATIONS VANDAL RESISTANT PUSH PLATES MORTISE CYLINDER STATIONS EXPLOSION-PROOF STATIONS VANDAL RESISTANT STATIONS EIGHT ZONE ANNUNCIATORS CUSTOM GRAPHIC ANNUNCIATORS PUSH BARS RELAYS ALARM...
-
Page 9: Limited Warranty
19 BRANDYWINE DRIVE, DEER PARK, NY 11729 (“seller”), warrants its SREX-100 active focused infrared detector, (the “product”), to be free from defects in material and workmanship for three years from date of original purchase,under normal use and serv- Seller’s obligation is limited to repairing or replacing, at its option, free of charge for parts, labor, or transportation, any part proven to be defective in material or workmanship under normal use and service.
Need help?
Do you have a question about the SREX-100 and is the answer not in the manual?
Questions and answers