Fault Localization When There Is A Problem With The Motor; Ordering Spare Parts - CO/Tech J1x-JF2-210 Owner's Manual

Fault localization when there
is a problem with the motor
1. To avoid overheating the motor, you should regularly blow the machine clean
or vacuum it so that sawdust and shavings do not affect the cooling.
2. Connect the saw to an earthed outlet with at least a 10 A fuse.
3. Immediately release the power switch if the motor does not start right up.
Unplug the power cord, check that the blade runs freely; try starting the motor
again if it runs freely.
4. If the motor stops during sawing: Immediately release the power switch and
unplug the power cord, release the blade from the workpiece, then try to start
the motor again.
5. Check connections, overload (several units connected to the same circuit,
spotlights, etc.), range (at least 1.5 mm² up to 7 metre length, at least 2 mm²
at 7 to 15 metres length), cable length (no more than 15 metres.)

Ordering spare parts

Please supply the following information when ordering spare parts:
• Type of machine
• The type number of the machine
• The article number of the machine
Disposal
Follow local ordinances when disposing of this product.
If you are unsure about how to dispose of this product
contact your municipality.
19